9560 Transaction Manager User's Manual - Intermec

REQ (Request for Acknowledgment)
Configuration Commands - REQ (Request for Acknowledgment)
Purpose: Enables or disables a request for a repeat handshake event. If REQ is
enabled, AFF and NEG must also be enabled.
Default: Disabled
Syntax: PDdata
Acceptable values for data are:
Any ASCII character
NUL = disable
Scan: To disable REQ, scan this label:
Disable REQ
*$+PD%U$-*
*$+PD%U$ - *
Or: To set REQ to an ASCII character:
1. Scan this label:
Set REQ
*+/$+PD*
*+/$+PD*
2. Scan a label for data from the full ASCII chart in Appendix B, “Full
ASCII Chart.”
3. Scan this label:
Exit Configuration, Save Settings
*$-*
*$ - *
7
7-43