9560 Transaction Manager User's Manual - Intermec

Configuration Commands - Records per Block
Records per Block
Purpose: Defines the maximum number of data records transmitted per block of data.
Usually files are transmitted record by record.
7-42
You must select the communications protocol before setting the parameters
that define the protocol.
Default: All records within block
Syntax: FCdata
Acceptable values for data are:
0 All records within block
1-99 Number of records per block
Scan: To set to all records, scan this label:
All
*$+FC0$-*
*$+FC0$-*
Or: To set the number of records per block to 1 through 99:
1. Scan this label:
Set Records per Block
*+/$+FC*
*+/$+FC*
2. Scan a label for 1 through 99 from the full ASCII chart in
Appendix B, “Full ASCII Chart.”
3. Scan this label:
Exit Configuration, Save Settings
*$-*
*$ - *