9560 Transaction Manager User's Manual - Intermec

9560 Transaction Manager User’s Manual
Using Batch Configuration
6-10
To configure several readers identically, you can print a bar code “menu” with
several parameters per label. A label can contain up to 48 characters, but this
many characters may not scan easily.
Each label should include the following, in this order:
• Start character (*). Intermec printers automatically generate this start
character.
• The Enter Configuration command ($+).
• Desired configuration commands and applicable data. See Chapter 7,
“Configuration Commands.”
• The Exit Configuration command ($-).
• Stop character (*). Intermec printers automatically generate this stop
character.
Batch Configuration Example
To configure the reader with Point-to-Point protocol using 2400 baud, scan the
following batch label:
*$+PA1IA4$-*
*$+PA1IA4$-*
The label contains the following information:
9560-53U