CutMaster 700 - Posch
CutMaster 700 - Posch
CutMaster 700 - Posch
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Maintenance<br />
40<br />
9.4.3.1<br />
9.5<br />
9.5.1<br />
9.5.2<br />
9.6<br />
Recommended transmission oils<br />
Manufacturer Oil specification<br />
OMV Gear Oil MP SAE 85W-90<br />
GENOL Gear oil MP 90<br />
FUCHS Titan Gear Hypoid SAE 90<br />
Any other transmission oil can be used, so long as it is in viscosity class SAE 90.<br />
Conveyor belt<br />
Conveyor belt - set central running<br />
1 Fastening screw 3 Tensioning screw<br />
2 Lock nut<br />
If the conveyor belt is not running centrally on the drive and/or tail pulleys, it is possible to<br />
adjust the direction of travel.<br />
▪ Slightly loosen the fastening screws on each side of the conveyor belt.<br />
▪ Loosen the lock nuts on both tensioning screws.<br />
▪ Align the return drum by tightening both tensioning screws evenly.<br />
▪ Tighten the lock nuts again.<br />
▪ Tighten the fastening screws on both sides.<br />
Tension conveyor belt<br />
The conveyor belt may become slack over time as a result of wear and tear. If this happens,<br />
the belt must be retensioned.<br />
▪ Extend the conveyor belt extension using the crank handle until the belt is completely<br />
tensioned.<br />
Cleaning<br />
Before carrying out any cleaning work on the machine, the drive unit MUST be switched off!<br />
Disconnect the machine from the mains.<br />
▪ In addition, pull out the plug of the device.<br />
Disengage the universal joint shaft on the tractor.<br />
▪ Before disengaging, turn the manual throttle to minimum.<br />
3<br />
2<br />
1
Change language