CutMaster 700 - Posch

More documents

Recommendations

Info

Checks 30 ▪ See: Changing the transmission oil [➙ 39]
9 9.1 9.1.1 9.2 Maintenance Before carrying out any maintenance on the machine, the drive unit MUST be switched off! Disconnect the machine from the mains. ▪ In addition, pull out the plug of the device. Disengage the universal joint shaft on the tractor. ▪ Before disengaging, turn the manual throttle to minimum. ▪ Remove the universal joint shaft from the tractor. Work on electrical equipment must only be carried out by qualified electricians. Never work without the protective guards in place. Only use original - POSCH - spare parts. Lubrication Dispose of oily and greasy parts and oil residues in accordance with legal regulations. Lubrication schedule 2 1 Lubrication intervals Item What/where Weekly (every 40 operating hours - or less depending on application) 3 1 Oil the saw blade to prevent corrosion 2 At central lubricating header 3 Both housing bearings at top of conveyor belt The lubrication points are marked with the lubricate symbol. Saw blade Always wear protective gloves when handling saw blades. Only strengthened POSCH saw blades may be used. Standard saw blades are too weak and pose a safety risk. Observe the maximum saw blade speed specified by the manufacturer. Maintenance 31
Page 1 and 2: Operating Instructions CutMaster 70
Page 3 and 4: Contents Contents 1 Foreword 5 1.1
Page 5 and 6: 1 1.1 1.2 1.3 1.4 Foreword Thank yo
Page 7 and 8: 2 2.1 Safety information Explanatio
Page 9 and 10: 2.4 2.5 The machine must always be
Page 11 and 12: 3 3.1 3.2 General Scope This user m
Page 13 and 14: 5 Three-point linkage connection 13
Page 15 and 16: 3.5 17 Rotational direction of pto
Page 17 and 18: 1 Neutral position 3 Delta position
Page 19 and 20: 4.3 The universal joint shaft must
Page 21 and 22: 5.1.2 5.1.3 "Comfort" model 1 2 1 F
Page 23 and 24: 5.3.2.1 5.3.3 1 Conveyor belt housi
Page 25 and 26: 6 Switching off the machine Before
Page 27 and 28: 7.3 Observe the road traffic regula
Page 29: 8.6 8.6.1 8.6.2 Oil level To check
Page 33 and 34: 9.2.1.1 9.2.2 1 Catch 2 Feed table
Page 35 and 36: 9.3.3 9.3.3.1 1 Transmission housin
Page 37 and 38: 9.3.3.3 9.4 9.4.1 Changing the V-be
Page 39 and 40: 9.4.2 9.4.3 Manufacturer Oil specif
Page 41 and 42: ▪ Remove the universal joint shaf
Page 43 and 44: 10.2 10.3 Loading plate for feed ta
Page 45 and 46: 11 Troubleshooting Before carrying
Page 47 and 48: 12 Technical data Type Z Z E11 Driv
Page 49 and 50: 13 Service POSCH product To order s
Page 52: Your Posch-Dealer

CutMaster 700 - Posch

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?