PACKAGE : I Bid Document VOLUME : II - Public Health Engineering

19.30 Equipment transfer trolley.
One MS structural construction, rubber tyre 4 wheel trolley having manual
push/pull arrangement from back/front with manual operating brake and brake lever
etc. shall be supplied, for placing and transfer of the equipments/components from
bank end to pump house over the gangway and vice versa. The trolley shall be
capable enough to transfer the heaviest components at one time subject to
minimum 1 (one) tonne capacity. The width and wheel base of the trolley shall be
such that it can easily move over the centre portion of the gangway after laying the
rising main for the present and keeping provision on laying one similar size rising
main for future at the flanks of the gangway. However the size of the trolley shall
be at least 1750 mm. long x 1500 mm. width.
19.31 Erection, testing and commissioning, operation and maintenance.
In addition to what has been stated close where in this document, the following
shall be undertaken.
All the equipments shall be installed at site following the test engineering practices
and the direction of the authorized representative of the employer observing all
recommendation and guide lines of the respective equipment manufacturers and
obeying all statutory rules, safety regulations, IE rules and acts etc. Appropriate tool
and tackles as would be required for proper installation/erection work shall be used.
The installation work shall include supply erection, grouting of all foundation bolts,
nuts, washers, channels, sole plate, machine plate, wages, supports etc. as would be
necessary for foundation, leveling, alignment etc. All Foundation pockets of the
Pump - Motor sets by suitable cement concrete mortar including supply of all
required materials shall be within the scope of this job. All false works, staging etc.
as would be necessary for proper erection shall be arranged by the contractor & the
same shall be removed after erection works including mending of all damages good
in the civil structure. It shall be mandatory to the contractor to arrange for technical
supervision of pump manufacture during erection process of the pumping sets &
furnish a certificate from the pump manufacturer to the effect that the pump motor
sets have been erected to their satisfaction & technical need of the pump motors for
giving desired performances have been fulfilled.
After completion of the erection works, the equipments have to pass through the
statutory & pre-commissioning tests & the contractor shall arrange the same at his
own cost.
Electrical power shall be provided thereafter by the employer for connection at the
incomer of the HT/L.T Panel Board.
DTS : Detailed Tender Specification. Page 207