Model MILA-5000 Infrared Lamp Heating System Instruction Manual

More documents

Recommendations

Info

Names of components of temperature controller E5AR Names of components on front panel • <strong>Model</strong> E5AR-T Action indicating light Channel display Program status display Bar graph Action indicating light Function key 1/run/reset key Function key 2 Level key Initial window ①Indicating light Components on initial window ① Indicating light SUB1: SUB1 lights when heating is started normally. - 18 - 1st display 2nd display 3rd display UP key DOWN key MODE key ② 1st display ③ 2nd display ④ 3rd display
SUB2: SUB2 lights if the overheating interlock is actuated. (SUB1 goes off simultaneously if SUB2 illuminates. ② 1 st display Displays the actual thermocouple temperature. ③ 2 nd display Displays the programmed temperature. ④ 3 rd display Displays the program pattern No. and step. How to input the temperature program The following program is set. Temperature o ( C) SP start - 19 - Action after end of operation "Continue" * The method of inputting the program above is described below as an example. Temperature program inputting procedure (1) Specify a PTN No. using the PF2 key. PTN1 is specified in the photo below. (2) Create a temperature program. 1. Press the Level key in the initial window to transfer control from “Operation Level” to “Program Setting Level”. Specify program No. “1” with “prgm: Edit program”. Up to maximum 32 programs can be created. A total of 256 steps can be registered. (Maximum 16 programs can be created (No. 1 to No. 16) and maximum 16 steps can be input.) To change the maximum input number of
Page 1 and 2: Model MILA-5000 Infrared Lamp Heati
Page 3 and 4: The contents of this manual are sub
Page 5 and 6: 1. Safety System ① Interlock agai
Page 7 and 8: Cooling water outlet port Quartz sa
Page 9 and 10: 8. Front panel of MILA Thermocouple
Page 11 and 12: 10. Names and Functions of Componen
Page 13 and 14: * In case of emergency (to stop hea
Page 15 and 16: 1. TC (+) (-) The Thermocouple volt
Page 17 and 18: - 13 -
Page 19 and 20: Specifications of E5AR-T Temperatur
Page 21: • Table of Inputs Set value Input
Page 25 and 26: 5. Press the Mode key twice and sel
Page 27 and 28: How to input (register) PID values
Page 29 and 30: Using PID pattern • When running
Page 31 and 32: • If AT is executed during resett
Page 33 and 34: How to set overheating (alarm) ①
Page 35 and 36: Other functions How to set thermoco
Page 37 and 38: Manual Setting For manual setting o
Page 39 and 40: Set data Set range Unit Initial val
Page 41: Other functions that are used often

Model MILA-5000 Infrared Lamp Heating System Instruction Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?