III. Gm-C Filtering - Epublications - Université de Limoges

More documents

Recommendations

Info

As <strong>de</strong>scribed in introduction, the Rauch filter exhibits a peaking in the GHz range. This peaking has been measured and can be observed in Figure 180. This peaking takes place at 2.47GHz and takes the value -9.5dB. The value of -9.5dB corresponds to the value of the transfer function for gain K = -1. This takes the value -9.5dB. H ( K 2 = −1) = . (IV.30) R 1 However, this peaking was expected at higher frequencies, close to 4GHz according to Figure 150. This shift towards lower frequencies is certainly due to capacitive parasitic. R + R Figure 180. Filter peaking at 2.47 GHz (-9.5dB) - 154 - 2
IV.4.c Performances Sum-up The filter ensures the high RF performances required for a silicon TV tuner, while keeping a large input voltage swing for the proposed selectivity, by power consumption increase. Table 29. Sum-up of the Rauch filter performances Rauch Filter Units f0 Tuning Range 45 - 240 MHz Q-factor 3 - Filter Gain at f0 10 dB NF 15 dB In-band IIP3 19 to 9 dBm Max. Input Power -5.5 dBm Supply 3.3 V Consumption 155 mW Technology BiCMOS 0.25µm - - 155 -
Page 1:
UNIVERSITE DE LIMOGES ECOLE DOCTORA
Page 5 and 6:
Acknowledgments En préambule à ce
Page 7 and 8:
Summary ACKNOWLEDGMENTS ...........
Page 9 and 10:
V. A PERSPECTIVE FOR FUTURE DEVELOP
Page 11 and 12:
French Introduction Les signaux TV
Page 13 and 14:
I. Introduction to TV tuners and to
Page 15 and 16:
I.1.b.ii Digital modulations In dig
Page 17 and 18:
makes the covering of a large terri
Page 19 and 20:
I.1.c.iii Terrestrial spectrum Firs
Page 21 and 22:
I.1.e Broadband Reception Systems F
Page 23 and 24:
I.2.b TV Tuner High Performance Spe
Page 25 and 26:
I.2.b.ii High linearity Although co
Page 27 and 28:
I.3 RF Filter Specifications I.3.a
Page 29 and 30:
27. This leads to the downconversio
Page 31 and 32:
These adjacent channel rejection re
Page 33 and 34:
Above 870MHz, there are no more ter
Page 35 and 36:
Newest silicon tuners generations,
Page 37 and 38:
I.6 References [I.1] B. Razavi, RF
Page 39 and 40:
II. Challenges of RF Selectivity Fo
Page 41 and 42:
Figure 39. H3 and N+5 rejections of
Page 43 and 44:
Figure 43. Second order Low-pass Fi
Page 45 and 46:
Figure 46 illustrates the transfer
Page 47 and 48:
H HPF s ( s) = s 1 + ω This corres
Page 49 and 50:
Topologies comparison for a same Q-
Page 51 and 52:
Figure 56. Low-pass to Notch Transf
Page 53 and 54:
II.2 Passive LC Second Order Bandpa
Page 55 and 56:
A possible solution is to split the
Page 57 and 58:
II.2.c Second Order Bandpass Filter
Page 59 and 60:
Figure 69. Band Switching Figure 70
Page 61 and 62:
Another paper [II.7] provides a FOM
Page 63 and 64:
A parallel self resonating circuit
Page 65 and 66:
This gives the following values for
Page 67 and 68:
Vb - 63 - M1 M2 Zin Figure 76. Anot
Page 69 and 70:
when given, reported noise figures
Page 71 and 72:
In all publications dedicated to Gm
Page 73 and 74:
II.4.c Second Order Bandpass Filter
Page 75 and 76:
Figure 87. Biquad Schematic The Gm-
Page 77 and 78:
Vin Rm - 73 - C Vout Figure 89. Der
Page 79 and 80:
Figure 93 depicts the RF performanc
Page 81 and 82:
A second advantage of advanced BiCM
Page 83 and 84:
II.7 Conclusion As a conclusion, th
Page 85 and 86:
[II.13] C. Andriesei, L. Goras, and
Page 87 and 88:
III.I Theoretical Study III. Gm-C F
Page 89 and 90:
g V m3 in III.1.b Linearity Conside
Page 91 and 92:
Assuming an ideal input transconduc
Page 93 and 94:
Figure 102. Linearity of the filter
Page 95 and 96:
Furthermore, a Gm-C circuit is not
Page 97 and 98:
In terms of noise, the Flicker nois
Page 99 and 100:
Table 7 summarizes the specificatio
Page 101 and 102:
Idiff (A) levels reached with this
Page 103 and 104:
III.2.e Unbalanced Differential Pai
Page 105 and 106:
Hence, the combination of the expon
Page 107 and 108: Technique Current Increase Source D
Page 109 and 110: Using this structure and considerin
Page 111 and 112: The dimensioning of the transistors
Page 113 and 114: III.3.c Gm-cells with MGTR III.3.c.
Page 115 and 116: Furthermore, the high sensitivity t
Page 117 and 118: Figure 136. Filter in-band IIP3 ver
Page 119 and 120: III.4 Comparison of the filters III
Page 121 and 122: III.5 Conclusion Once the Gm-C seco
Page 123 and 124: IV. Rauch Filtering IV.1 Sallen-Key
Page 125 and 126: Thus, an equation linking Q and Gai
Page 127 and 128: IV.1.c.ii Proposed positive feedbac
Page 129 and 130: For both Rauch and Sallen-Key filte
Page 131 and 132: The high sensitivity to passive com
Page 133 and 134: Furthermore, it should also be take
Page 135 and 136: IV.2.b Innovative Implementation of
Page 137 and 138: esulting gain K, constituted of the
Page 139 and 140: Table 25. Sum-up of the OA specific
Page 141 and 142: Figure 153. OA voltage gain versus
Page 143 and 144: Filtering in the mirror, by means o
Page 145 and 146: However, this feedback makes the fi
Page 147 and 148: Figure 160. OA Gain and phase versu
Page 149 and 150: IV.3.c Implemented Filter and Test
Page 151 and 152: Figure 165 depicts the layout of th
Page 153 and 154: Figure 169. PVT variations of the f
Page 155 and 156: IV.4 Rauch Filter Performances: Mea
Page 157: Figure 178. IIP3 versus input power
Page 161 and 162: Table 30. Frequency Limitations of
Page 163 and 164: IV.7 References [IV.1] Y. Tsividis
Page 165 and 166: V. A Perspective for Future Develop
Page 167 and 168: V.2 4-path Filter Simulations V.2.a
Page 169 and 170: The frequency tunability is ensured
Page 171 and 172: V.3 State-of-the-Art V.3.a 4-path F
Page 173 and 174: V.4 Conclusion In this chapter, it
Page 175 and 176: IEEE International, 2009, pp. 222-2
Page 177 and 178: RF selectivity challenges In this t
Page 179 and 180: The positive feedback Rauch filter
Page 181 and 182: It is worth highlighting that FOM1
Page 183 and 184: étudiée. Il s’avère que la lin
Page 185 and 186: It is worth noticing that S0 only d
Page 187 and 188: A.3 Signal-to-Noise Ratio These dif
Page 189 and 190: A.5 Friis’ Formula In case of mul
Page 191 and 192: A.7 References [A.1] Friis, H.T., N
Page 193 and 194: To estimate the influence of the di
Page 195 and 196: Now, let’s have a look to the cub
Page 197 and 198: Figure 200. Third order intercept p
Page 199 and 200: B.2 RF Filter Linearity Measurement
Page 201 and 202: B.2.c IIP2 measurement To measure t
Page 203 and 204: - 199 -
Page 205 and 206: C.1 Gyrator-C filtering year Ref. f
Page 207 and 208: C.2 Gm-C Filtering year Ref. f0 (MH
Page 209 and 210:
year C.3 Rm-C filtering Ref. f0 (MH
Page 211 and 212:
C.5 References C.5.a Gyrator-C filt
Page 213 and 214:
[C.23] J. De Lima and C. Dualibe,
Page 215 and 216:
- 211 -
Page 217 and 218:
this gives: I I I md d1 d 2 = I I =
Page 219 and 220:
D.2 MOS Degenerated Common-Source C
Page 221 and 222:
⎛ I s ⎞ Vout = Vin + U T ln ⎜
Page 223 and 224:
Computing, this leads to: V out + v
Page 225 and 226:
- 221 -
Page 227 and 228:
- 223 -
Page 229 and 230:
FIGURE 54. H3 AND N+5 REJECTIONS AC
Page 231 and 232:
FIGURE 168. PVT VARIATIONS OF THE F
Page 233 and 234:
- 229 -
show all

III. Gm-C Filtering - Epublications - Université de Limoges

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?