Optoelectronics with Carbon Nanotubes
Optoelectronics with Carbon Nanotubes Optoelectronics with Carbon Nanotubes
Abstract of the Dissertation Optoelectronics with Carbon Nanotubes by Megumi Kinoshita Doctor of Philosophy in Physics Stony Brook University 2011 The carbon nanotube is a promising material for future micro- and nano-scale electronics because of its unique electronic properties, high carrier mobility and extraordinary capacity for high current density. In particular, semiconducting carbon nanotubes are direct bandgap materials with a typical energy gap in the order of 1 eV, which means they emit light in the nearinfrared range, making them an attractive option in telecommunications applications. However, there have been few systematic investigations of electrically-induced light emission (i.e. electroluminescence) from carbon nanotubes, and their emission properties are not well understood. In this dissertation, we explore the characteristics of electroluminescence in three different types of carbon-nanotube devices. The first is a single-tube field-effect transistor (CNTFET), whose emission has previously been found to have a very broad spectral shape and low emission efficiency. We analyze the spectral shape in detail, which reveals that a high electric field near metal contacts contributes most to the bias-dependent component of broadening, in addition to smaller contributions from tube nonuniformity, inelastic scattering of phonons, high temperature, etc. In the second part of the study, single-tube light-emitting diodes are constructed by employing a split top-gate scheme. The split gate creates p- and n-doped regions electrostatically, so that electrons and holes combine between the two sections and can decay radiatively. This configuration creates electron-hole pairs under much lower electric fields and gives us a greater control over carrier distribution in the device channel, resulting in much narrower spectral linewidths and an emission intensity several orders of magnitude larger than that of CNTFETs. The much better signal-to-noise also leads to the observation of emission from defect-induced states. Finally, we extend the idea of the single-tube p–n diode and fabricate CNT film diodes from many purified tubes aligned in parallel. While the operating principle is somewhat different from that of single-tube diodes because of the presence of metallic tubes in the material, the film iii
diodes nonetheless show a rectifying behavior and much greater light intensity than single-tube devices. With their superior light output and robustness, they bring us one step closer to a realworld application of carbon nanotubes optoelectronics. iv
- Page 1 and 2: Stony Brook University The official
- Page 3: Stony Brook University The Graduate
- Page 7 and 8: Table of Contents Abstract ........
- Page 9 and 10: Chapter I List of Figures Figure
- Page 11 and 12: Figure V-3 Source-drain electric
- Page 13 and 14: My parents have been steadfast supp
- Page 15 and 16: This work explores both fundamental
- Page 17 and 18: In fact, we typically have no knowl
- Page 19 and 20: (a) (b) Figure I-2 (a) Energy dispe
- Page 21 and 22: (a) (b) metallic Figure I-4. One-di
- Page 23 and 24: optical absorption peaks for differ
- Page 25 and 26: elax rapidly to lower non-radiative
- Page 27 and 28: The disorder-induced band (D-band)
- Page 29 and 30: The saturation limit for semiconduc
- Page 31 and 32: (a) (b) Figure I-7. (a) A schematic
- Page 33 and 34: assisted tunneling through Schottky
- Page 35 and 36: majority carriers that gain enough
- Page 37 and 38: conventional ambipolar emission. Th
- Page 39 and 40: on quartz, which remains a signific
- Page 41 and 42: Chapter II Methods 1. Materials One
- Page 43 and 44: diameter (< 2 nm) SWNTs at IBM T. J
- Page 45 and 46: devices were annealed in vacuum at
- Page 47 and 48: 3. Experimental set-up The optical
- Page 49 and 50: off wavelengths of 2150 nm, 2000 nm
- Page 51 and 52: Chapter III Unipolar, High-Bias Emi
- Page 53 and 54: Figure III-1. Semi-log plot of drai
diodes nonetheless show a rectifying behavior and much greater light intensity than single-tube<br />
devices. With their superior light output and robustness, they bring us one step closer to a realworld<br />
application of carbon nanotubes optoelectronics.<br />
iv