FTA Manual.pdf - Industrial Air

63 9810.0156 – Rev.04 –12/01/2007
Installation
Please take precuations to protect the boiler from
back flow of water that occured as a result of liquifying of
waste gases.
It is an essential to comply with the procedures and
standards about chimneys that gas distrubition companies
and CE standards stated.
Caution! Mount an air relief device onto outlet pipe
of boiler hot water. Air relief device must be installed by
installator company in accordance with installation to the
points where air may be exist on installation except boiler.
Carrying and transportation must be done together
with original packaging material of device considering the
marking on the boiler. Please protect the boiler against
factors that can damage to packaging material and device.
Caution! Check the slants of boiler installation
connetions with a water gauge. After slants have been
done There must not been air in the system. Never use a
valve between expansion valve and the boiler. Set air
pressure in expansion tank depending on system pressure.
Device will be out of warranty in case of setting failure or
undone settings.
Caution! A safety relief valve in accordance with
CE standards must be mounted onto the boiler which was
mentioned in technical data table. There must not be any
valve, armature, diameter reduction, elbow etc between
boiler and safety valve. The boiler will be out of warranty in
case of unconnection and/or wrong connection of safety
valve. At least one unit spare safety valve must be located
onto installation as close to the boiler.
Caution! As the boiler works or in case of operation
of the boiler without water, water must not be pumped to
the boiler directly. The boiler water must be gave at low
temperature when the boiler does not operate. Otherwise
system may come to harm. Cold water must not be
pumped into hot boiler. Otherwise the boiler will be out of
warranty and manufacturer company is not responsible for
physical and sipiritual damages.
15