pSOSystem System Calls - Read

pHILE+ Error Codes Error Codes
TABLE B-3 pHILE+ Error Codes (Continued)
Hex Mnemonic and Description System Call(s)
0x2005 E_VINITPAR: Illegal parameters to
init_vol(). The parameters specified to an
init_vol() call are not consistent. One of the
following problems has been detected by the
pHILE+ file system manager.
■ The specified starting location of the bitmap
causes the FLIST to either extend beyond
the end of the volume or the end of the control
block region (if the volume has been
partitioned into control and data block regions.)
■ The specified starting block for the data
block region (SODATA) is not on a modulo 8
boundary, or it is beyond the end of the volume.
■ The bitmap begins in blocks 0-3.
0x2006 E_MNTFULL: Attempt to mount too many volumes.
Attempt to mount more volumes than
specified by the pHILE+ Configuration Table parameter
fc_nmount.
0x2007 E_VALIEN: Wrong volume format. The volume to
be mounted is not of the correct. Either it is the
wrong type, i.e. mounting an MS-DOS volume
with mount_vol(), or it has not been formatted
by the pHILE+ file system manager.
0x2008 E_MNTED: Volume already mounted. This error
condition implies one of the following:
■ An attempt was made to mount a device
that is already mounted.
■ An attempt was made to initialize a
mounted volume.
0x2009 E_MNTOPEN: Cannot unmount volume; files
open. An attempt was made to unmount a volume
when one or more of its files are still open.
All files must be closed before a volume can be
unmounted.
init_vol
cdmount_vol,
mount_vol,
nfsmount_vol,
pcmount_vol
cdmount_vol,
mount_vol,
pcmount_vol,
verify_vol
cdmount_vol,
init_vol, mount_vol,
nfsmount_vol,
pcinit_vol,
pcmount_vol
unmount_vol,
verify_vol
B-16 pSOSystem System Calls