ALIENWARE ALX DESKTOP MANUAL Reproduction of this manual ...

Removing a Memory Module
4
Alienware ALX Desktop Manual
Press outward on the retention clips at each end of the module. This will release the
module from the memory socket.
Installing a Memory Module
1. Press outward on the retention clips at each end of the empty memory socket.
2. Orient the memory module so that any notches in its edge connector are in
alignment with the keys in the memory socket.
3. Press the memory module straight down into the memory socket, applying
even pressure at each end; the retention clips will snap into the notches at
each end of the memory module, securing it in the socket.
4. Reconnect the power cord, monitor, keyboard and mouse.
5. Turn on the computer and check that the memory is detected properly.
6. Click Start (Windows® Logo) > Control Panel > System and Maintenence.
7. Click ‘View amount of RAM and processor speed’ located in the
‘System’ section.
8. The amount of memory installed is displayed under the ‘System’ heading.