8196446 - Frymaster

More documents

Recommendations

Info

2.10.1 RTI Manifold and Accessories cont. ITEM PART # COMPONENT √ 1 106-6830 Solenoid Assembly 2 108-0446 Valve, RTI Waste Assembly (see page 2-32 for parts) 3 810-1668 Adaptor, Male ⅝” OD x ½” 4 220-5658 Cover, RTI Dust Plug 5 807-4760 Harness, RTI – MIB connection 6 810-1057 Flexline, ⅝” OD x 13-inch long 7 810-1668 Adaptor, Male ⅝” OD x ½” 8 810-3263 Flexline, ½” OD x 36-inch long 9 813-0555 Reducer, Bell Fitting, ½” to ¼” NPT BM 10 810-3531 Valve, Check 20 PSI RTI bypass 11 810-3583 Valve, Check ½” NPT 4 PSI RTI Manifold 12 810-3596 Manifold, RTI 13 813-0003 Tee, ½” x ½” x ½” BM 14 810-3738 Adaptor, Check Valve Close Nipple 15 813-0062 Elbow, ½” Blk 90° 16 813-0093 Nipple, ½” x 4-inch 17 813-0062 Elbow, ½” BM 90° 18 813-0261 Nipple, ½” x 5-inch NPT 19 813-0304 Bushing, ½” x ¼” 20 813-0345 Elbow, ½ Blk 45° 21 813-0336 Plug, ½” NPT Square Head 22 813-0838 Nipple, ¼” NPT 23 220-5656 Brace, RTI Handle 24 220-5657 Cover, RTI Handle 25 823-7142 Handle, RTI Waste Pull 26 810-3587 Lock and Key, RTI Waste Handle 27 809-0601 Clip, Clevis Left Rod End √ Recommended parts. 2-29
2.10.2 RTI Dispose Waste Valve ITEM PART # COMPONENT 108-0446 Valve, RTI Dispose Waste 1 108-0445 Bracket, RTI Waste Valve 2 220-5615 Handle, RTI Waste Valve 3 807-4936 Microswitch, Gold Sealed 4 810-0278 Valve, ½” Ball 5 900-2935 Retainer, Nut Return Valve 6 901-2348 Cover, DV Safety Switch 7 902-2348 Cover, DV Safety Switch 2.10.3 RTI Test Box ITEM PART # COMPONENT √ 108-0716 Box, LOV RTI Test √ Recommended parts. 2-30
Page 1 and 2:
This equipment chapter is to be ins
Page 3 and 4:
DANGER Improper installation, adjus
Page 5 and 6:
• no fryer will be warranted unde
Page 7 and 8:
BIELA14 SERIES GEN II LOV ELECTRIC
Page 9 and 10:
3. Remove the two screws from the u
Page 11 and 12:
4. Locate the red (or yellow) and w
Page 13 and 14:
Full vat element wire routing 3 6 2
Page 15 and 16:
4. The contactors and relays are he
Page 17 and 18:
23. Position the element tube assem
Page 19 and 20:
Disconnect flexlines indicated by t
Page 21 and 22:
Problem Probable Causes Corrective
Page 23 and 24:
1.10.3 Replacing the ATO board, LON
Page 25 and 26:
1.11.2 MIB (Manual Interface Board)
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
1.12.2 RTI LOV Wiring 1.12.3 Frymas
Page 33 and 34:
8. “Filling” is displayed durin
Page 35 and 36:
1.13.2 AIF (Auto Intermittent Filtr
Page 37 and 38:
1.13.5 Replacing a Rotary Actuator
Page 39 and 40: Problem Probable Causes Corrective
Page 41 and 42: 1.14.3 Service Required Errors A SE
Page 43 and 44: 1.14.5 Tech Mode Tech mode allows t
Page 45 and 46: 1.14.7 M3000 Menu Summary Tree Refl
Page 47 and 48: 1.15 Loading and Updating Software
Page 49 and 50: 1.17 Interface Board Diagnostic Cha
Page 51 and 52: 1.19 Wiring Diagrams 1.19.1 Compone
Page 53 and 54: 1.19.3 Component Wiring (CSA) 1-46
Page 55 and 56: 1.19.5 Contactor Box - Delta Config
Page 57 and 58: 1.19.7 Simplified BIELA14 LOV Gen I
Page 59 and 60: 1.19.9 Simplified BIELA14 LOV Gen I
Page 61 and 62: 1.19.11 BIELA14 Gen II Series LOV S
Page 63 and 64: 2.2 Doors, Sides, Tilt Housings, Ca
Page 65 and 66: 2.3.2 Drain Valves and Associated P
Page 67 and 68: 2.4.1 Component Boxes cont. ITEM PA
Page 69 and 70: 2.4.2.1 Left and Right Contactor Bo
Page 71 and 72: 2.4.3.1 Element Assemblies and Hard
Page 73 and 74: 2.4.3.2 Element Tube Assemblies con
Page 75 and 76: 2.4.5.3 Contactor Box Wiring Assemb
Page 77 and 78: 2.4.5.6 Component Box and Filter Pu
Page 79 and 80: 2.5 Filtration System Components 2.
Page 81 and 82: 2.5.2 Auto Intermittent Filtration
Page 83 and 84: 2.6 Frypot Assemblies and Associate
Page 85 and 86: 2.7 Oil Return Manifolds ITEM PART
Page 87 and 88: 2.9.2 JIB Cap and Pick Up Assembly
Page 89: 2.10 RTI 2.10.1 RTI Manifold and Ac
Page 93 and 94: 2.12 Fasteners ITEM PART # COMPONEN
show all

8196446 - Frymaster

Create successful ePaper yourself

Delete template?

Save as template?