Sewing Machine - Brother
Sewing Machine - Brother
Sewing Machine - Brother
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
—————————————————————————————————————————————————————————————————————————————————————————————————————————————————————<br />
e<br />
f<br />
Hold the end of the thread, push the bobbin<br />
down with your finger, and then pass the<br />
thread through the slit, as shown.<br />
If the thread is not correctly inserted through<br />
the tension-adjusting spring of the bobbin<br />
case, it may cause incorrect thread tension<br />
(page 41).<br />
1<br />
a Tension-adjusting spring<br />
Replace the bobbin cover. Put the left tab in<br />
place (see arrow a), and then press lightly on<br />
the right side (see arrow b) until the cover<br />
clicks into place.<br />
Replace the cover so that the end of the<br />
thread comes out from the left side of the<br />
cover (as shown by the line in the diagram).<br />
■ For models equipped with the quick-set bobbin<br />
Memo<br />
● The direction for feeding the bobbin thread<br />
is indicated by marks on the needle plate<br />
cover. Be sure to thread the machine as<br />
indicated.<br />
a<br />
Raise the needle to its highest position by turning<br />
the handwheel toward you (counterclockwise) or<br />
press (needle position button) (for models<br />
equipped with the needle position button), and<br />
raise the presser foot lever.<br />
Turn off the sewing machine.<br />
b<br />
Slide the button and open the cover.<br />
c<br />
1 2<br />
d<br />
a Cover<br />
b Slide button<br />
Insert the bobbin with your right hand so that the<br />
end of the thread is on the left, and then, after<br />
pulling the thread firmly around the tab with your<br />
left hand as shown, lightly pull the thread to<br />
guide it through the slit.<br />
a Tab<br />
CAUTION<br />
● Make sure you set the bobbin so the thread<br />
unrolls in the right direction. If the thread unrolls<br />
in the wrong direction, it may cause the thread<br />
tension to be incorrect or break the needle.<br />
21<br />
1