Blaster CD 8x - Creative

More documents

Recommendations

Info

Conventions The following typographical conventions are in effect throughout this document. Bold Bold face type identifies words and phrases that are to be entered exactly as shown. For example: SET SOUND=C:\SB16 Italic Italic type identifies words and phrases that are to be replaced by you. For example: VOC2WAV sample.VOC When using this command, you must supply a value for sample. Italic is used to emphasize a word/phrase, or to identify a word/phrase that is being defined. In this document, it is used to identify a button or menu item that you are to select; for example, “Select the Play button on the main menu.” [Brackets] Brackets indicate command parameters that are optional; if you choose not to include optional values, there may be default values that are automatically inserted. For example: PCXDriver=[ON|OFF] In this command, you can set PCXDriver on/off; the command has a default that is substituted if you do not make a selection. {Braces} Braces indicate command parameters that must be included. For example: {source l-vol}[,r-vol] In this command, you must enter values for source and l-vol; a value for r-vol is optional. If required parameter values are not included, the command is ignored or returns an error message. Introduction v
. . . Ellipses indicate that the preceding parameter can be repeated. For example, in the command below, you can include any number of source values: SET [RECMIX|OUTMIX] level source[+source][...] ALL CAPS A word in all capital letters identifies a key you are to press. For example, “Select the Yes button and press the ENTER key.” Important information is designated with either of two icons. For example: Indicates information that has special interest for all users. Read this message before you proceed. Designates a caution or warning that can help you avoid situations involving risk. Introduction vi
Page 1 and 2: Blaster CD 8x User Guide On-line Ve
Page 3 and 4: Appendix A Troubleshooting CD-ROM D
Page 5 and 6: Regulatory Information Notice for t
Page 7: System Requirements Disk Backup To
Page 11 and 12: Installing the CD-ROM Drive Figure
Page 13 and 14: Connecting the CD-ROM Drive to the
Page 15 and 16: Installing the Interface Card Use t
Page 17 and 18: The data cable is designed to fit i
Page 19 and 20: 2. Connect the CD-ROM audio cable t
Page 21 and 22: 2 Installing the Blaster CD 8x Soft
Page 23 and 24: 8. When the installation is complet
Page 25 and 26: 8. Choose Next. The Choose Destinat
Page 27 and 28: 11. The Setup Complete dialog appea
Page 29 and 30: Installing Software in DOS/Windows
Page 31 and 32: Testing the Installation The test p
Page 33 and 34: To add Windows QuickCD to Accessori
Page 35 and 36: Using the Control Menu The Control
Page 37 and 38: DOS QuickCD To run DOS QuickCD: Nex
Page 39 and 40: Using the Mouse Place the mouse cur
Page 41 and 42: Solutions: The problem may be corre
Page 43 and 44: DOS Applications PROBLEM: There is
Page 45 and 46: Using Creative IDE CD-ROM Drive in
Page 47 and 48: MSCDEX.EXE Select the primary port
Page 49 and 50: q You have changed the resource set
Page 51 and 52: Legacy Cards Section Add Button Eac
Page 53 and 54: Adding a CD-ROM Drive You can daisy
Page 55 and 56: In DOS/Windows 3.x After connecting
Page 57 and 58: Typical Audio Performance Sampling
Page 59 and 60:
North, Central, and South America I
show all

Blaster CD 8x - Creative

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?