Blaster CD 8x - Creative

More documents

Recommendations

Info

User’s Guide Blaster CD 8x with Plug-and-Play Interface Card Copyright © 1996 by Creative Labs, Inc. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of Creative Labs, Inc. Sound Blaster is a registered trademark of Creative Technology, Ltd. MS-DOS and Windows are registered trademarks of Microsoft Corporation. All other products are trademarks or registered trademarks of their respective owners.
Regulatory Information Notice for the USA FCC Part 15: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try one or more of the following measures: q Reorient or relocate the receiving antenna. q Increase the separation between the equipment and receiver. q Connect the equipment into an outlet on a circuit different from that of the receiver connected. q Consult the dealer or an experienced radio/TV technician for help. Caution To comply with the limits for the Class B digital device, pursuant to Part 15 of the FCC Rules, this device must be installed in computer equipment certified to comply with the Class B limits. All cables used to connect the computer and peripherals must be shielded and grounded. Operation with non-certified computers or non-shielded cables may result in interference to radio or television reception. Modifications Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the device. Notice for Canada This apparatus complies with the Class “B” limits for radio interference as specified in the Canadian Department of Communications Radio Interference Regulations. Cet appareil est conforme aux normes de CLASSE “B” d’interference radio tel que spécifié par le Ministère Canadien des Communications dans les règlements d’interférence radio. Safety Information CAUTION: This device is intended to be installed by the user in a CSA/TUV/UL certified/listed IBM AT or compatible personal computer in the manufacturer’s defined operator access area. Check the equipment operating/installation manual and/or with the equipment manufacturer to verify/confirm if your equipment is suitable for user-installed application cards. ATTENTION: Cette carte est destinée à être installée par l’utilisateur, dans un ordinateur compatible certifié CSA/TUV/UL ou listé IBM AT, à l’intérieur de la zone définie par le fabricant. Consulter le mode d’emploi ou le fabricant de l’appareil pour vérifier ou confirmer si l’utilisateur peut y installer lui-même des cartes périphériques. Compliance This product is in conformity to the Council Directive 89/336/EEC, 92/31/EEC (EMC).
Page 1 and 2: Blaster CD 8x User Guide On-line Ve
Page 3: Appendix A Troubleshooting CD-ROM D
Page 7 and 8: System Requirements Disk Backup To
Page 9 and 10: . . . Ellipses indicate that the pr
Page 11 and 12: Installing the CD-ROM Drive Figure
Page 13 and 14: Connecting the CD-ROM Drive to the
Page 15 and 16: Installing the Interface Card Use t
Page 17 and 18: The data cable is designed to fit i
Page 19 and 20: 2. Connect the CD-ROM audio cable t
Page 21 and 22: 2 Installing the Blaster CD 8x Soft
Page 23 and 24: 8. When the installation is complet
Page 25 and 26: 8. Choose Next. The Choose Destinat
Page 27 and 28: 11. The Setup Complete dialog appea
Page 29 and 30: Installing Software in DOS/Windows
Page 31 and 32: Testing the Installation The test p
Page 33 and 34: To add Windows QuickCD to Accessori
Page 35 and 36: Using the Control Menu The Control
Page 37 and 38: DOS QuickCD To run DOS QuickCD: Nex
Page 39 and 40: Using the Mouse Place the mouse cur
Page 41 and 42: Solutions: The problem may be corre
Page 43 and 44: DOS Applications PROBLEM: There is
Page 45 and 46: Using Creative IDE CD-ROM Drive in
Page 47 and 48: MSCDEX.EXE Select the primary port
Page 49 and 50: q You have changed the resource set
Page 51 and 52: Legacy Cards Section Add Button Eac
Page 53 and 54: Adding a CD-ROM Drive You can daisy
Page 55 and 56:
In DOS/Windows 3.x After connecting
Page 57 and 58:
Typical Audio Performance Sampling
Page 59 and 60:
North, Central, and South America I
show all

Blaster CD 8x - Creative

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?