0404 Owner's Manual - Creative

More documents

Recommendations

Info

7 - Appendix Word Clock In/Out To Synchronize PatchMix DSP to an External Clock Source: 1. Make sure an external clock source is connected to the E-MU Digital Audio System hardware via the word clock or S/PDIF input. 2. Open the Session Settings dialog box. 3. Under the System tab, select External Source, then select either Word Clock or S/PDIF. 4. Press OK to close the dialog box. 5. Check the Sync section of PatchMix DSP to verify that the Locked indicator is illuminated. Devices can be connected in daisy chain fashion (word clock out connected to the next unit’s word clock in) or in parallel for one or two devices, but professional digital studios normally use a master word clock generator or “House Sync” with a distribution system so that each device receives a phase-coherent and jitter-free word clock. House Sync Generator Digital Device 1 Digital Device 2 A master word clock generator is preferable for larger digital setups. Digital Device 3 Digital Device 4 Word Clock In: Receives word clock (sample clock) from another digital device such as a digital video deck, digital recorder or digital mixer. Word Clock Out: Sends word clock (sample clock) to another digital recorder. Word clock is always output, whether it is generated by the internal clock or passed through from the word clock input. 75Ω On/Off: Termination for the word clock input can be switched on or off in the Sync Card menu of the PatchMix DSP application. Normally word clock termination should be left on. If you have problems with a weak word clock signal, try turning termination off. See Word Clock Termination. The diagram below shows the proper way to connect and terminate a serial word clock chain. Using a BNC “T” connector ensures that word clock is precisely in phase for both devices. The middle device has termination turned Off and the last device in the word clock chain has termination turned On. 74 <strong>Creative</strong> Professional
S/PDIF Digital SYNC CARD ADAT Optical DIGITAL BREAKOUT CABLE Digital Mixer Word Clock Termination OFF S/PDIF Word Clock T - connector Word Clock Termination ON This diagram shows the proper way to connect word clock if you don’t have a multi-output word clock generator. The last device in a Word Clock chain should have Termination ON. 7 - Appendix Word Clock In/Out E-MU Digital Audio System 75 IN IN Word Clock
Page 1 and 2:
0404 Digital Audio System Owner's M
Page 3 and 4:
Table of Contents 1- Introduction .
Page 5 and 6:
Freq Shifter ......................
Page 7 and 8:
1- Introduction Welcome! Thank you
Page 9 and 10:
2 - Installation Setting Up the Dig
Page 11 and 12:
6. 7. 8. 9. Do not force the E-MU 0
Page 13 and 14:
3 - PCI Card & Interfaces The E-MU
Page 15 and 16:
The S/PDIF out can be configured as
Page 17 and 18:
4 - The PatchMix DSP Mixer PatchMix
Page 19 and 20:
The Toolbar New Session Open Sessio
Page 21 and 22:
You can now create either a blank n
Page 23 and 24:
Input Mixer Strips PatchMix DSP Lin
Page 25 and 26:
Insert Section The Insert Section i
Page 27 and 28:
ASIO Direct Monitor Send/Return Thi
Page 29 and 30:
Meter Color Indicates E Red Indicat
Page 31 and 32: Aux Section The Auxiliary Sends tap
Page 33 and 34: Level, Pan, Solo & Mute Controls Th
Page 35 and 36: TV Screen & Selectors The “TV scr
Page 37 and 38: Auxiliary Effects & Returns The sec
Page 39 and 40: 5 - Effects Overview PatchMix DSP c
Page 41 and 42: Creating, Renaming & Deleting Folde
Page 43 and 44: Method #2 1. Right-click over the E
Page 45 and 46: Core Effects Descriptions 1-Band Pa
Page 47 and 48: 4-Band EQ This 4-band equalizer pro
Page 49 and 50: Chorus An audio delay in the range
Page 51 and 52: Parameter Description Attack Time C
Page 53 and 54: Freq Shifter This unusual effect is
Page 55 and 56: Mono Delay 3000 A delay line makes
Page 57 and 58: Speaker Simulator The Speaker Simul
Page 59 and 60: Stereo Reverb Reverberation is a si
Page 61 and 62: 6 - Working with ASIO ASIO ASIO sta
Page 63 and 64: Basic Recording The following step
Page 65 and 66: The Cubasis Demo Song Screen Inspec
Page 67 and 68: Direct Monitoring Direct Monitor Se
Page 69 and 70: Direct Monitor Routing In Cubasis (
Page 71 and 72: Using External Sends & Returns An E
Page 73 and 74: To Setup and use E-Wire: Setup Patc
Page 75 and 76: E-Delay Units Parameter The Units v
Page 77 and 78: 7 - Appendix Sync Daughter Card Sup
Page 79 and 80: Stripe Mode This mode is used to re
Page 81: Duplicating SMPTE time code The Syn
Page 85 and 86: Technical Specifications GENERAL Sa
Page 87 and 88: Internet References The internet co
Page 89 and 90: Compliance Information United State
Page 91 and 92: Index Numerics 1-Band Para EQ 37 1-
Page 93 and 94: fader 25 insert 17 label 25 mute bu
show all

0404 Owner's Manual - Creative

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?