ECL Comfort 210/310, A275/A375 Installation Guide - Danfoss ...
ECL Comfort 210/310, A275/A375 Installation Guide - Danfoss ...
ECL Comfort 210/310, A275/A375 Installation Guide - Danfoss ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Installation</strong> <strong>Guide</strong> <strong>ECL</strong> <strong>Comfort</strong> <strong>210</strong> / <strong>310</strong>, application <strong>A275</strong> / <strong>A375</strong><br />
2.6.2 <strong>ECL</strong> Application Key, copying data<br />
General principles<br />
When the controller is connected and operating, you can check<br />
and adjust all or some of the basic settings. The new settings can<br />
be stored on the Key.<br />
How to update the <strong>ECL</strong> Application Key after settings have<br />
been changed?<br />
All new settings can be stored on the <strong>ECL</strong> Application Key.<br />
How to store factory setting in the controller from the<br />
Application Key?<br />
Please read the paragraph concerning Application Key, Situation<br />
1: The controller is new from the factory, the <strong>ECL</strong> Application Key<br />
is not inserted.<br />
How to store personal settings from the controller to the Key?<br />
Please read the paragraph concerning Application Key, Situation 3:<br />
A copy of the controllers settings is needed for configuring another<br />
controller<br />
As a main rule, the <strong>ECL</strong> Application Key should always remain in<br />
the controller. If the Key is removed, it is not possible to change<br />
settings.<br />
Factory settings can always be restored.<br />
Make a note of new settings in the 'Settings overview' table.<br />
Do not remove the <strong>ECL</strong> Application Key while copying. The data on<br />
the <strong>ECL</strong> Application Key can be damaged!<br />
It is possible to copy settings from one <strong>ECL</strong> <strong>Comfort</strong> controller to<br />
another controller provided that the two controllers are from the same<br />
series (<strong>210</strong> or <strong>310</strong>).<br />
80 DEN-SMT/DK VI.GU.L1.02 <strong>Danfoss</strong> District Energy