M12 Oncore Users Guide Supplement - deetc - isel

More documents

Recommendations

Info

Response Message (Continued) Motorola GPS Products M12 Oncore User’s Guide Supplement Revision 1.0 01/25/00 POSITION/STATUS/DATA (12 CHANNEL) Motorola Binary Format UTC Parameters u Bit 7: UTC mode 1 = enabled 0 = disabled Bit 6: UTC offset 1 = decoded 0 = NOT decoded Bits 5 – 0: Present UTC offset value, range –32…+31; from GPS time* (ignore if Bit 6 = 0). GMT Offset s signed byte of GMT offset 00 = positive, ff = negative h hour of GMT offset 0…+23 m minute of GMT offset 0…59 vvvvvv ID tag 6 characters (0x20 to 0x7e) C checksum Message Length: 154 bytes * Represents UTC time offset from GPS time. Offset is rounded to the nearest integer value 84
Motorola GPS Products M12 Oncore User’s Guide Supplement Revision 1.0 01/25/00 Page intentionally left blank. 85
Page 1 and 2:
M12 User’s Guide Supplement
Page 3 and 4:
General Characteristics Performance
Page 5 and 6:
3. Mechanical 3.1 Mechanical Drawin
Page 7 and 8:
5.2 Main power Motorola GPS Product
Page 9 and 10:
8. Performance 8.1 Accuracy Motorol
Page 11 and 12:
10. Serial I/O Messages 10.1 Soluti
Page 13 and 14:
Motorola GPS Products M12 Oncore Us
Page 15 and 16:
Input Command Response Message Moto
Page 17 and 18:
Input Command SATELLITE IGNORE LIST
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Input Command POSITION-HOLD POSITIO
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34: Input Command Response Message Moto
Page 63 and 64: Input Command Response Message @ #
Page 83: Response Message (Continued) Motoro
Page 89 and 90: Motorola GPS Products M12 Oncore Us
Page 93 and 94: Output Command Motorola GPS Product
Page 97 and 98: Input Command GPGLL (GEOGRAPHIC POS
Page 111 and 112: Satellite Mask Angle Function Contr
Page 113 and 114: Position-Hold Position Function Inp
Page 115 and 116: RTCM Port Mode Function Sets the ba
Page 117 and 118: Almanac Data Output Function Output
Page 119 and 120: Almanac Data Input Function Manuall
Page 121 and 122: ASCII Position Output Function The
Page 123 and 124: Position Control Function Sets the
Page 125 and 126: Oscillator Learning Function Reques
Page 127 and 128: Controller ID cid Run Command run M
show all

M12 Oncore Users Guide Supplement - deetc - isel

Create successful ePaper yourself

Delete template?

Save as template?