M12 Oncore Users Guide Supplement - deetc - isel

More documents

Recommendations

Info

Motorola GPS Products M12 Oncore User’s Guide Supplement Revision 1.0 01/25/00 1PPS CONTROL This message allows the user to choose how the 1PPS output in the receiver will behave. The selection will be remembered through power cycles if battery back-up is provided. Default mode: Continuous 72
Input Command Response Message Motorola GPS Products M12 Oncore User’s Guide Supplement Revision 1.0 01/25/00 1PPS CONTROL Motorola Binary Format • Poll Current 1PPS Setting: @@GcxC x 1 out of range byte $ff C checksum Message Length: 8 bytes • Change Current 1PPS Setting: @@GcpC p 1PPS control 0 = 1PPS disabled 1 = 1PPS on continuously 2 = pulse active only when tracking at least one satellite C checksum Message Length: 8 bytes • To either input command: @@GcpC p 1PPS control 0 = 1PPS disabled 1 = 1PPS on continuously 2 = pulse active only when tracking at least one satellite C checksum Message Length: 8 bytes 73
Page 1 and 2:
M12 User’s Guide Supplement
Page 3 and 4:
General Characteristics Performance
Page 5 and 6:
3. Mechanical 3.1 Mechanical Drawin
Page 7 and 8:
5.2 Main power Motorola GPS Product
Page 9 and 10:
8. Performance 8.1 Accuracy Motorol
Page 11 and 12:
10. Serial I/O Messages 10.1 Soluti
Page 13 and 14:
Motorola GPS Products M12 Oncore Us
Page 15 and 16:
Input Command Response Message Moto
Page 17 and 18:
Input Command SATELLITE IGNORE LIST
Page 19 and 20:
Input Command Response Message Moto
Page 21 and 22: Input Command Response Message Moto
Page 25 and 26: Input Command POSITION-HOLD POSITIO
Page 63 and 64: Input Command Response Message @ #
Page 71: Input Command Response Message Moto
Page 83 and 84: Response Message (Continued) Motoro
Page 85 and 86: Motorola GPS Products M12 Oncore Us
Page 89 and 90: Motorola GPS Products M12 Oncore Us
Page 93 and 94: Output Command Motorola GPS Product
Page 97 and 98: Input Command GPGLL (GEOGRAPHIC POS
Page 111 and 112: Satellite Mask Angle Function Contr
Page 113 and 114: Position-Hold Position Function Inp
Page 115 and 116: RTCM Port Mode Function Sets the ba
Page 117 and 118: Almanac Data Output Function Output
Page 119 and 120: Almanac Data Input Function Manuall
Page 121 and 122: ASCII Position Output Function The
Page 123 and 124:
Position Control Function Sets the
Page 125 and 126:
Oscillator Learning Function Reques
Page 127 and 128:
Controller ID cid Run Command run M
show all

M12 Oncore Users Guide Supplement - deetc - isel

Create successful ePaper yourself

Delete template?

Save as template?