M12 Oncore Users Guide Supplement - deetc - isel

More documents

Recommendations

Info

Motorola GPS Products M12 Oncore User’s Guide Supplement Revision 1.0 01/25/00 POSITION FILTER SELECT This message enables or disables the position filter. The default value will be filter enabled. The selection will be remembered through power cycles if battery back-up is provided. Default mode: Enabled 38
Input Command Response Message Motorola GPS Products M12 Oncore User’s Guide Supplement Revision 1.0 01/25/00 POSITION FILTER SELECT Motorola Binary Format • Poll current Position Filter Selection: @@AQxC x 1 out of range byte $ff C checksum Message Length: 8 bytes • Change current Position Filter Selection: @@AQsC s selection 0 = Disabled 1 = Enabled C checksum Message Length: 8 bytes • To either command: @@AQsC s selection 0 = Disabled 1 = Enabled C checksum Message Length: 8 bytes 39
Page 1 and 2: M12 User’s Guide Supplement
Page 3 and 4: General Characteristics Performance
Page 5 and 6: 3. Mechanical 3.1 Mechanical Drawin
Page 7 and 8: 5.2 Main power Motorola GPS Product
Page 9 and 10: 8. Performance 8.1 Accuracy Motorol
Page 11 and 12: 10. Serial I/O Messages 10.1 Soluti
Page 13 and 14: Motorola GPS Products M12 Oncore Us
Page 15 and 16: Input Command Response Message Moto
Page 17 and 18: Input Command SATELLITE IGNORE LIST
Page 25 and 26: Input Command POSITION-HOLD POSITIO
Page 37: Input Command Response Message Moto
Page 63 and 64: Input Command Response Message @ #
Page 83 and 84: Response Message (Continued) Motoro
Page 85 and 86: Motorola GPS Products M12 Oncore Us
Page 89 and 90:
Motorola GPS Products M12 Oncore Us
Page 91 and 92:
Input Command Response Message Moto
Page 93 and 94:
Output Command Motorola GPS Product
Page 95 and 96:
Page 97 and 98:
Input Command GPGLL (GEOGRAPHIC POS
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Satellite Mask Angle Function Contr
Page 113 and 114:
Position-Hold Position Function Inp
Page 115 and 116:
RTCM Port Mode Function Sets the ba
Page 117 and 118:
Almanac Data Output Function Output
Page 119 and 120:
Almanac Data Input Function Manuall
Page 121 and 122:
ASCII Position Output Function The
Page 123 and 124:
Position Control Function Sets the
Page 125 and 126:
Oscillator Learning Function Reques
Page 127 and 128:
Controller ID cid Run Command run M
show all

M12 Oncore Users Guide Supplement - deetc - isel

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?