M12 Oncore Users Guide Supplement - deetc - isel

More documents

Recommendations

Info

Motorola GPS Products M12 Oncore User’s Guide Supplement Revision 1.0 01/25/00 RTCM PORT MODE This command allows the user to select the baud rate of the RTCM serial input port (pin 8). The allowable baud rates are 2400, 4800 and 9600. The baud rate of this secondary port is independent of the status of the primary serial port. Default mode: 9600 baud 36
Input Command Response Message Motorola GPS Products M12 Oncore User’s Guide Supplement Revision 1.0 01/25/00 RTCM PORT MODE Motorola Binary Format • Poll current RTCM Port Mode: @@AObC x 1 out of range byte $ff C checksum Message length: 8 bytes • Change current RTCM Port Mode: @@AObC b RTCM port baud rate 0 = 9600 1 = 4800 2 = 2400 C checksum Message length: 8 bytes • To either command: @@AObC b RTCM port baud rate 0 = 9600 1 = 4800 2 = 2400 C checksum Message length: 8 bytes 37
Page 1 and 2: M12 User’s Guide Supplement
Page 3 and 4: General Characteristics Performance
Page 5 and 6: 3. Mechanical 3.1 Mechanical Drawin
Page 7 and 8: 5.2 Main power Motorola GPS Product
Page 9 and 10: 8. Performance 8.1 Accuracy Motorol
Page 11 and 12: 10. Serial I/O Messages 10.1 Soluti
Page 13 and 14: Motorola GPS Products M12 Oncore Us
Page 15 and 16: Input Command Response Message Moto
Page 17 and 18: Input Command SATELLITE IGNORE LIST
Page 25 and 26: Input Command POSITION-HOLD POSITIO
Page 35: Input Command Response Message Moto
Page 63 and 64: Input Command Response Message @ #
Page 83 and 84: Response Message (Continued) Motoro
Page 85 and 86: Motorola GPS Products M12 Oncore Us
Page 87 and 88:
Input Command Response Message Moto
Page 89 and 90:
Motorola GPS Products M12 Oncore Us
Page 91 and 92:
Page 93 and 94:
Output Command Motorola GPS Product
Page 95 and 96:
Page 97 and 98:
Input Command GPGLL (GEOGRAPHIC POS
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Satellite Mask Angle Function Contr
Page 113 and 114:
Position-Hold Position Function Inp
Page 115 and 116:
RTCM Port Mode Function Sets the ba
Page 117 and 118:
Almanac Data Output Function Output
Page 119 and 120:
Almanac Data Input Function Manuall
Page 121 and 122:
ASCII Position Output Function The
Page 123 and 124:
Position Control Function Sets the
Page 125 and 126:
Oscillator Learning Function Reques
Page 127 and 128:
Controller ID cid Run Command run M
show all

M12 Oncore Users Guide Supplement - deetc - isel

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?