M12 Oncore Users Guide Supplement - deetc - isel

More documents

Recommendations

Info

Motorola GPS Products M12 Oncore User’s Guide Supplement Revision 1.0 01/25/00 SWITCH TO BINARY This utility command switches the serial data format on the primary port from NMEA 0183 to Motorola binary. The baud rate of the port is switched from 4800 to 9600 and input commands are recognized in Motorola binary format only. 108
Input Command Response Message Motorola GPS Products M12 Oncore User’s Guide Supplement Revision 1.0 01/25/00 SWITCH TO BINARY NMEA-0183 Format • Switch to Binary format: $PMOTG,FOR,xCC x format 0 = Motorola binary CC optional checksum • There is no response message to this input command. NOTE: The Motorola DOS controller software does not support NMEA messages. 109
Page 1 and 2:
M12 User’s Guide Supplement
Page 3 and 4:
General Characteristics Performance
Page 5 and 6:
3. Mechanical 3.1 Mechanical Drawin
Page 7 and 8:
5.2 Main power Motorola GPS Product
Page 9 and 10:
8. Performance 8.1 Accuracy Motorol
Page 11 and 12:
10. Serial I/O Messages 10.1 Soluti
Page 13 and 14:
Motorola GPS Products M12 Oncore Us
Page 15 and 16:
Input Command Response Message Moto
Page 17 and 18:
Input Command SATELLITE IGNORE LIST
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Input Command POSITION-HOLD POSITIO
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58: Input Command Response Message Moto
Page 63 and 64: Input Command Response Message @ #
Page 83 and 84: Response Message (Continued) Motoro
Page 85 and 86: Motorola GPS Products M12 Oncore Us
Page 89 and 90: Motorola GPS Products M12 Oncore Us
Page 93 and 94: Output Command Motorola GPS Product
Page 97 and 98: Input Command GPGLL (GEOGRAPHIC POS
Page 107: Input Command Response Message Moto
Page 111 and 112: Satellite Mask Angle Function Contr
Page 113 and 114: Position-Hold Position Function Inp
Page 115 and 116: RTCM Port Mode Function Sets the ba
Page 117 and 118: Almanac Data Output Function Output
Page 119 and 120: Almanac Data Input Function Manuall
Page 121 and 122: ASCII Position Output Function The
Page 123 and 124: Position Control Function Sets the
Page 125 and 126: Oscillator Learning Function Reques
Page 127 and 128: Controller ID cid Run Command run M
show all

M12 Oncore Users Guide Supplement - deetc - isel

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?