SERVICE BULLETIN REFRIGERATION

More documents

Recommendations

Info

f) Solder the two cables. h) Insert the cables of the new temperature sensor into the two 15 mm heat shrink tubings. g) Insert the cable into the 50 mm heat shrink tubing. i) Solder the cables of the new temperature sensor with the cables of the cable pulled out before. j) Warm up the two heat shrink tubings to k) Warm up the 50 mm heat shrink tubing to insulate the 2 soldered junctions. insulate the cables with the junctions. FAULTY TEMPERATURE SENSOR 38/39
l) Fit the new sensor into its original housing. Note: place the cable so that it doesn’t get in contact with the grid’s hooks shown in the figure, in order to avoid damaging the cable when fitting the grid. m) Reposition the protection grid of the temperature sensor. FAULTY TEMPERATURE SENSOR 39/39
Page 1 and 2: FAULTY TEMPERATURE SENSOR Electroni
Page 3 and 4: INVOLVED MODELS Tab. A Faulty tempe
Page 5 and 6: Faulty temperature sensor PNC DATE
Page 25 and 26: Appendix KIT A1 REPLACEMENT PROCEDU
Page 27 and 28: f) Cut and remove the end of the sl
Page 29 and 30: Note: The new electronic board uses
Page 31 and 32: d) Cut the cable of the faulty temp
Page 33 and 34: n) Fit the new sensor into the cove
Page 35 and 36: f) Insert the cable into the 50 mm
Page 37: Appendix KIT D REPLACEMENT PROCEDUR

SERVICE BULLETIN REFRIGERATION

Create successful ePaper yourself

Delete template?

Save as template?