SERVICE BULLETIN REFRIGERATION
SERVICE BULLETIN REFRIGERATION SERVICE BULLETIN REFRIGERATION
j) Warm up the 50 mm heat shrink tubing to insulate the cables with the junctions. k) Fit the new sensor into its original housing. The exceeding cable must be properly positioned. FAULTY TEMPERATURE SENSOR 36/39
Appendix KIT D REPLACEMENT PROCEDURE FOR APPLIANCES WITH A D – 50286485003 KIT Warning! Unplug the appliance, before carrying out the operations. a) Remove the drawers and/or the shelves from the inside of the appliance. b) Remove the protection grid of the temperature sensor. Note: the protection grid might be different according to the appliance. d) Cut the cable of the faulty temperature sensor. c) Remove the faulty temperature sensor. e) Cut and remove the sleeve according to the measures shown in the figure. FAULTY TEMPERATURE SENSOR 37/39 5 5
- Page 1 and 2: FAULTY TEMPERATURE SENSOR Electroni
- Page 3 and 4: INVOLVED MODELS Tab. A Faulty tempe
- Page 5 and 6: Faulty temperature sensor PNC DATE
- Page 7 and 8: Faulty temperature sensor PNC DATE
- Page 9 and 10: Faulty temperature sensor PNC DATE
- Page 11 and 12: Faulty temperature sensor PNC DATE
- Page 13 and 14: Faulty temperature sensor PNC DATE
- Page 15 and 16: Faulty temperature sensor PNC DATE
- Page 17 and 18: Faulty temperature sensor PNC DATE
- Page 19 and 20: Faulty temperature sensor PNC DATE
- Page 21 and 22: Faulty temperature sensor PNC DATE
- Page 23 and 24: Faulty temperature sensor PNC DATE
- Page 25 and 26: Appendix KIT A1 REPLACEMENT PROCEDU
- Page 27 and 28: f) Cut and remove the end of the sl
- Page 29 and 30: Note: The new electronic board uses
- Page 31 and 32: d) Cut the cable of the faulty temp
- Page 33 and 34: n) Fit the new sensor into the cove
- Page 35: f) Insert the cable into the 50 mm
- Page 39: l) Fit the new sensor into its orig
Appendix KIT D<br />
REPLACEMENT PROCEDURE FOR APPLIANCES WITH A D – 50286485003 KIT<br />
Warning! Unplug the appliance, before carrying out the operations.<br />
a) Remove the drawers and/or the shelves from the inside of the appliance.<br />
b) Remove the protection grid of the<br />
temperature sensor.<br />
Note: the protection grid might be different<br />
according to the appliance.<br />
d) Cut the cable of the faulty temperature<br />
sensor.<br />
c) Remove the faulty temperature sensor.<br />
e) Cut and remove the sleeve according to the<br />
measures shown in the figure.<br />
FAULTY TEMPERATURE SENSOR 37/39<br />
5<br />
5