SERVICE BULLETIN REFRIGERATION

More documents

Recommendations

Info

Appendix KIT C and C1 REPLACEMENT PROCEDURE FOR APPLIANCES WITH KIT C - 50286484006 KIT C1 - 50292572000 Warning! Unplug the appliance, before carrying out the operations. a) Remove the drawers and/or the shelves from the inside of the appliance. b) Access the faulty temperature sensor. Note: the support of the temperature sensor might be different according to the appliance. 5 5 d) Cut and remove the sleeve according to the measures shown in the figure. c) Cut the cable of the faulty temperature sensor after checking that the new sensor reaches its place. Only for the Kit C1, for isolation reasons, the cable of the new sensor must not be shortened! The exceeding cable must be properly positioned later. e) Solder the two cables. FAULTY TEMPERATURE SENSOR 34/39
f) Insert the cable into the 50 mm heat shrink tubing. h) Solder the cables of the new temperature sensor with the cables of the cable pulled out before. g) Insert the cables of the new temperature sensor into the two heat shrink tubings. i) Warm up the two heat shrink tubings to insulate the 2 soldered junctions. FAULTY TEMPERATURE SENSOR 35/39
Page 1 and 2: FAULTY TEMPERATURE SENSOR Electroni
Page 3 and 4: INVOLVED MODELS Tab. A Faulty tempe
Page 5 and 6: Faulty temperature sensor PNC DATE
Page 25 and 26: Appendix KIT A1 REPLACEMENT PROCEDU
Page 27 and 28: f) Cut and remove the end of the sl
Page 29 and 30: Note: The new electronic board uses
Page 31 and 32: d) Cut the cable of the faulty temp
Page 33: n) Fit the new sensor into the cove
Page 37 and 38: Appendix KIT D REPLACEMENT PROCEDUR
Page 39: l) Fit the new sensor into its orig

SERVICE BULLETIN REFRIGERATION

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?