SERVICE BULLETIN REFRIGERATION

More documents

Recommendations

Info

j) Insert the cables of the new temperature sensor into the two 15 mm heat shrink tubings. l) Warm up the two heat shrink tubings to insulate the 2 soldered junctions. k) Solder the cables of the new temperature sensor with the cables of the cable pulled out before. m) Warm up the 50 mm heat shrink tubing to insulate the cables with the junctions. FAULTY TEMPERATURE SENSOR 32/39
n) Fit the new sensor into the cover of the housing and fit the cable as shown in figure. p) Fit the cover in the rectangular seat in the compartment (if no seat is there, place the cover so as not to interfere with the drawers and/or with the shelves) and fix it with the screw supplied with the kit. o) Insert the element P in the hole previously drilled in the compartment (where the cable comes out). q) Fit the screw cover. FAULTY TEMPERATURE SENSOR 33/39 P
Page 1 and 2: FAULTY TEMPERATURE SENSOR Electroni
Page 3 and 4: INVOLVED MODELS Tab. A Faulty tempe
Page 5 and 6: Faulty temperature sensor PNC DATE
Page 25 and 26: Appendix KIT A1 REPLACEMENT PROCEDU
Page 27 and 28: f) Cut and remove the end of the sl
Page 29 and 30: Note: The new electronic board uses
Page 31: d) Cut the cable of the faulty temp
Page 35 and 36: f) Insert the cable into the 50 mm
Page 37 and 38: Appendix KIT D REPLACEMENT PROCEDUR
Page 39: l) Fit the new sensor into its orig

SERVICE BULLETIN REFRIGERATION

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?