SERVICE BULLETIN REFRIGERATION

More documents

Recommendations

Info

Appendix KIT B REPLACEMENT PROCEDURE FOR APPLIANCES WITH A B – 50286483008 KIT Warning! Unplug the appliance, before carrying out the operations. a) Remove the drawers and/or the shelves from the inside of the appliance. INDENTATION EXEMPLE b) Identify the indentation on the compartment wall (see example above). To make sure that the indentation’s position is in the correct place, check Service Instructions publ. no. 599374207. c) Drill a 10 mm hole in the compartment just next to the indentation. FAULTY TEMPERATURE SENSOR 30/39
d) Cut the cable of the faulty temperature sensor. f) Pull out the cable of the temperature sensor. h) Solder the two cables. e) Take the cable with some pliers (note: the faulty sensor must not be removed from the inside of the compartment). g) Cut and remove the sleeve according to the measures shown in the figure. i) Insert the cable into the 50 mm heat shrink tubing. FAULTY TEMPERATURE SENSOR 31/39 5 5 60min – 70max
Page 1 and 2: FAULTY TEMPERATURE SENSOR Electroni
Page 3 and 4: INVOLVED MODELS Tab. A Faulty tempe
Page 5 and 6: Faulty temperature sensor PNC DATE
Page 25 and 26: Appendix KIT A1 REPLACEMENT PROCEDU
Page 27 and 28: f) Cut and remove the end of the sl
Page 29: Note: The new electronic board uses
Page 33 and 34: n) Fit the new sensor into the cove
Page 35 and 36: f) Insert the cable into the 50 mm
Page 37 and 38: Appendix KIT D REPLACEMENT PROCEDUR
Page 39: l) Fit the new sensor into its orig

SERVICE BULLETIN REFRIGERATION

Create successful ePaper yourself

Delete template?

Save as template?