SERVICE BULLETIN REFRIGERATION
SERVICE BULLETIN REFRIGERATION SERVICE BULLETIN REFRIGERATION
Appendix KIT B REPLACEMENT PROCEDURE FOR APPLIANCES WITH A B – 50286483008 KIT Warning! Unplug the appliance, before carrying out the operations. a) Remove the drawers and/or the shelves from the inside of the appliance. INDENTATION EXEMPLE b) Identify the indentation on the compartment wall (see example above). To make sure that the indentation’s position is in the correct place, check Service Instructions publ. no. 599374207. c) Drill a 10 mm hole in the compartment just next to the indentation. FAULTY TEMPERATURE SENSOR 30/39
d) Cut the cable of the faulty temperature sensor. f) Pull out the cable of the temperature sensor. h) Solder the two cables. e) Take the cable with some pliers (note: the faulty sensor must not be removed from the inside of the compartment). g) Cut and remove the sleeve according to the measures shown in the figure. i) Insert the cable into the 50 mm heat shrink tubing. FAULTY TEMPERATURE SENSOR 31/39 5 5 60min – 70max
- Page 1 and 2: FAULTY TEMPERATURE SENSOR Electroni
- Page 3 and 4: INVOLVED MODELS Tab. A Faulty tempe
- Page 5 and 6: Faulty temperature sensor PNC DATE
- Page 7 and 8: Faulty temperature sensor PNC DATE
- Page 9 and 10: Faulty temperature sensor PNC DATE
- Page 11 and 12: Faulty temperature sensor PNC DATE
- Page 13 and 14: Faulty temperature sensor PNC DATE
- Page 15 and 16: Faulty temperature sensor PNC DATE
- Page 17 and 18: Faulty temperature sensor PNC DATE
- Page 19 and 20: Faulty temperature sensor PNC DATE
- Page 21 and 22: Faulty temperature sensor PNC DATE
- Page 23 and 24: Faulty temperature sensor PNC DATE
- Page 25 and 26: Appendix KIT A1 REPLACEMENT PROCEDU
- Page 27 and 28: f) Cut and remove the end of the sl
- Page 29: Note: The new electronic board uses
- Page 33 and 34: n) Fit the new sensor into the cove
- Page 35 and 36: f) Insert the cable into the 50 mm
- Page 37 and 38: Appendix KIT D REPLACEMENT PROCEDUR
- Page 39: l) Fit the new sensor into its orig
Appendix KIT B<br />
REPLACEMENT PROCEDURE FOR APPLIANCES WITH A B – 50286483008 KIT<br />
Warning! Unplug the appliance, before carrying out the operations.<br />
a) Remove the drawers and/or the shelves from the inside of the appliance.<br />
INDENTATION EXEMPLE<br />
b) Identify the indentation on the compartment<br />
wall (see example above).<br />
To make sure that the indentation’s position<br />
is in the correct place, check Service<br />
Instructions publ. no. 599374207.<br />
c) Drill a 10 mm hole in the compartment just next<br />
to the indentation.<br />
FAULTY TEMPERATURE SENSOR 30/39