SERVICE BULLETIN REFRIGERATION

More documents

Recommendations

Info

j) Connect the cables of the new connector of the sensor to the soldered cables. Note: before soldering, fit the two 15 mm heat shrink tubings to the cables of the new connector. l) Connect the connectors to the new power board. View of the power board (from the component side) J1 wiring connector (5 pin) J3 temperature sensor connector (6 pin) k) Warm up the two heat shrink tubings to insulate the 2 soldered junctions. FAULTY TEMPERATURE SENSOR 28/39
Note: The new electronic board uses only the air temperature sensor of the refrigerator. In some models the previous FLEC electronic board displayed GREEN digits. The new electronic board displays only RED digits. FAULTY TEMPERATURE SENSOR 29/39
Page 1 and 2: FAULTY TEMPERATURE SENSOR Electroni
Page 3 and 4: INVOLVED MODELS Tab. A Faulty tempe
Page 5 and 6: Faulty temperature sensor PNC DATE
Page 25 and 26: Appendix KIT A1 REPLACEMENT PROCEDU
Page 27: f) Cut and remove the end of the sl
Page 31 and 32: d) Cut the cable of the faulty temp
Page 33 and 34: n) Fit the new sensor into the cove
Page 35 and 36: f) Insert the cable into the 50 mm
Page 37 and 38: Appendix KIT D REPLACEMENT PROCEDUR
Page 39: l) Fit the new sensor into its orig

SERVICE BULLETIN REFRIGERATION

Create successful ePaper yourself

Delete template?

Save as template?