HP LaserJet M1005 MFP user guide - ENWW
HP LaserJet M1005 MFP user guide - ENWW
HP LaserJet M1005 MFP user guide - ENWW
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
To adjust the default copy size<br />
NOTE The default copy size is the size to which copies are normally reduced or enlarged. If<br />
you keep the factory default size setting of Original=100%, all copies will be the same size as<br />
the original document.<br />
1. On the device control panel, press Menu/Enter.<br />
2. Use the < or the > button to select Copy setup, and then press Menu/Enter.<br />
3. Use the < or the > button to select Def. Reduce/Enlrg, and then press Menu/Enter.<br />
4. Use the < or the > button to select the option for how you normally want to reduce or enlarge<br />
copies.<br />
NOTE If you select Custom: 25-400%, type in the percentage of the original size that<br />
you normally want for copies.<br />
If you select 2 pages/sheet or 4 pages/sheet, select the orientation (portrait or<br />
landscape).<br />
5. Press Menu/Enter to save the selection.<br />
Copying multiple pages on one sheet of paper<br />
1. On the device control panel, press More Copy Settings.<br />
2. Use the < or the > button to select Reduce/Enlarge, and then press Menu/Enter.<br />
3. Use the < or the > button to select 2 pages/sheet or 4 pages/sheet, and then press Menu/Enter.<br />
4. Use the < or the > button to select Portrait or Landscape, and then press Start Copy.<br />
5. Wait for the scanner to stop scanning. The Next Page [OK] to Continue message appears.<br />
6. Remove the original from the flatbed scanner, put the next original onto the scanner, and then<br />
close the lid.<br />
7. Press OK.<br />
● If you selected 2 pages/sheet, the device prints the copy with two original pages on one<br />
page.<br />
● If you selected 4 pages/sheet, repeat steps 6 and 7 two more times. The device prints the<br />
copy with four original pages on one page<br />
NOTE The change in the setting remains active for about two minutes after the copy job has<br />
been completed. During this time, Settings=Custom appears on the device control-panel<br />
display.<br />
You must change the default media size in the media input tray to match the output size, or<br />
part of your copy might be cut off.<br />
48 Chapter 6 Copy <strong>ENWW</strong>