HP LaserJet M1005 MFP user guide - ENWW

Adjusting the lighter/darker (contrast) setting
The lighter/darker setting affects the lightness or darkness (contrast) of the copy. Use the following
procedure to change the contrast for the current copy job only.
To adjust the lighter/darker setting for the current job
1. On the device control panel, press Lighter/Darker to see the current contrast setting.
2. Use the < or the > button to adjust the setting. Move the slider to the left to make the copy
lighter than the original, or move the slider to the right to make the copy darker than the original.
3. Press Start Copy to save the selection and immediately start the copy job, or press Menu/Enter
to save the selection without starting the job.
NOTE The change in the setting remains active for about two minutes after the copy job
has been completed. During this time, Settings=Custom appears on the device controlpanel
display.
To adjust the default lighter/darker setting
NOTE The default lighter/darker setting affects all copy jobs.
1. On the device control panel, press Menu/Enter.
2. Use the < or the > button to select Copy setup, and then press Menu/Enter.
3. Use the < or the > button to select Def. Light/dark, and then press Menu/Enter.
4. Use the < or the > button to adjust the setting. Move the slider to the left to make all of the
copies lighter than the original, or move the slider to the right to make all of the copies darker
than the original.
5. Press Menu/Enter to save the selection.
46 Chapter 6 Copy ENWW