HP LaserJet M1005 MFP user guide - ENWW

More documents

Recommendations

Info

FCC compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ● Reorient or relocate the receiving antenna. ● Increase separation between equipment and receiver. ● Connect equipment to an outlet on a circuit different from that to which the receiver is located. ● Consult your dealer or an experienced radio/TV technician. NOTE Any changes or modifications to the printer that are not expressly approved by Hewlett-Packard could void the user's authority to operate this equipment. Use of a shielded interface cable is required to comply with the Class B limits of Part 15 of FCC rules. Environmental Product Stewardship program Protecting the environment Hewlett-Packard Company is committed to providing quality products in an environmentally sound manner. This product has been designed with several attributes to minimize impacts on our environment. Ozone production This product generates no appreciable ozone gas (O3). Power consumption Power usage drops significantly while in PowerSave/Sleep mode, which saves natural resources and saves money without affecting the high performance of this product. This product qualifies for ENERGY STAR® (Version 1.0), which is a voluntary program established to encourage the development of energy-efficient office products. 118 Appendix D Regulatory information ENWW
ENERGY STAR is a U.S. registered service mark of the U.S. Environmental Protection Agency. As an ENERGY STAR® partner, Hewlett-Packard Company has determined that this product meets ENERGY STAR® Guidelines for energy efficiency. For more information, see www.energystar.gov. Toner consumption EconoMode uses significantly less toner, which might extend the life of the print cartridge. Paper use The device manual duplex features (two-sided printing) (see Printing on both sides for Windows and Printing on both sides (Macintosh) for Macintosh) and N-up printing capability (multiple pages printed on one sheet) (see Printing multiple pages on one sheet of paper for Windows and Printing multiple pages on one sheet of paper (Macintosh) for Macintosh) can reduce paper usage and the resulting demands on natural resources. Plastics Plastic parts over 25 grams are marked according to international standards that enhance the ability to identify plastics for recycling purposes at the end of the device's life. ENWW Environmental Product Stewardship program 119
Page 1:
HP LaserJet M1005 MFP User Guide
Page 4 and 5:
Copyright and License © 2006 Copyr
Page 6 and 7:
Envelope storage ..................
Page 8 and 9:
Output bin ........................
Page 10 and 11:
viii ENWW
Page 12 and 13:
Device features Print ● Prints le
Page 14 and 15:
Control panel 1 2 3 4 9 8 5 6 7 1 C
Page 16 and 17:
Minimum system requirements In orde
Page 18 and 19:
Printer driver The device comes wit
Page 20 and 21:
Software for Windows See the gettin
Page 22 and 23:
12 Chapter 2 Software ENWW
Page 24 and 25:
General guidelines Some media might
Page 26 and 27:
Guidelines for using media The foll
Page 28 and 29:
Envelopes HP recommends that you pr
Page 30 and 31:
Letterhead and preprinted forms Let
Page 32 and 33:
Table 3-2 Tray 1 specifications Med
Page 34 and 35:
24 Chapter 3 Media specifications E
Page 36 and 37:
Loading media The following section
Page 38 and 39:
Controlling print jobs This section
Page 40 and 41:
To change the default media type 1.
Page 42 and 43:
Using features in the Windows print
Page 44 and 45:
Setting a custom paper size from th
Page 46 and 47:
4. After one side has been printed,
Page 48 and 49:
Printing a cover page (Macintosh) I
Page 50 and 51:
6. Maintaining the same orientation
Page 52 and 53:
Canceling a print job If a print jo
Page 54 and 55:
Starting a copy job To make copies
Page 56 and 57:
Adjusting the lighter/darker (contr
Page 58 and 59:
To adjust the default copy size NOT
Page 60 and 61:
Copying onto media of different typ
Page 62 and 63:
Copying two-sided documents Copying
Page 64 and 65:
Copying photos and books To copy a
Page 66 and 67:
56 Chapter 6 Copy ENWW
Page 68 and 69:
Understanding scanning methods You
Page 70 and 71:
Scanning by using other software Th
Page 72 and 73:
2. Gently close the lid. 3. Gently
Page 74 and 75:
Resolution and color guidelines The
Page 76 and 77:
Information pages Information pages
Page 78 and 79: Outside the United States, you can
Page 80 and 81: 2. Clean the white document lid bac
Page 82 and 83: 4. Insert the cartridge into the de
Page 84 and 85: Problem-solving checklist Step numb
Page 86 and 87: Clearing jams This section contains
Page 88 and 89: Input trays CAUTION Do not use shar
Page 90 and 91: Output bin CAUTION Do not use sharp
Page 92 and 93: Control-panel messages The majority
Page 94 and 95: Control panel message Description R
Page 96 and 97: 3. Click Properties, or click Print
Page 98 and 99: Problem Cause Solution Toner smears
Page 100 and 101: Problem Cause Solution Toner appear
Page 102 and 103: Problem Cause Solution The device d
Page 104 and 105: Problem Cause Solution Black dots o
Page 106 and 107: Performance problems Problem Cause
Page 108 and 109: Scan-quality problems Preventing pr
Page 110 and 111: Solving common Macintosh problems P
Page 112 and 113: Problem-solving tools The section d
Page 114 and 115: Supplies Product name Description P
Page 116 and 117: 106 Appendix A Accessories and orde
Page 118 and 119: Hewlett-Packard limited warranty st
Page 120 and 121: Availability of support and service
Page 122 and 123: Guidelines for repacking the device
Page 124 and 125: Physical specifications Table C-1 P
Page 126 and 127: 116 Appendix C Device specification
Page 130 and 131: HP LaserJet printing supplies It's
Page 132 and 133: Declaration of conformity Declarati
Page 134 and 135: Finnish laser statement LASERTURVAL
Page 136 and 137: USB Universal serial bus (USB) is a
Page 138 and 139: default media size and type, settin
Page 140 and 141: troubleshooting Macintosh 100 types
Page 142: selecting trays by 28 specification
show all

HP LaserJet M1005 MFP user guide - ENWW

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?