T-FLEX Parametric CAD. Fundamentals. 2D Design

An alternative way of maximizing a window is double-clicking
on the window title.
If a window has a title bar, that is, it is not maximized, then the
window management context menu can be called by pointing at the
icon at the left end of the title bar and clicking . For a maximized
window, this icon is located in the very left of the application textual
menu bar.
The terms “collapse” and “expand” will further be used along with
“minimize” and “maximize” respectively.
When a window is restored down, its size can be modified. Simply
move the cursor over any window edge until it changes to a doubleheaded
arrow, and then drag the edge of the window to the desired
size.
Selection of active window
Main Concepts of System Operation
The active window (i.e. the window of the current document) can be selected in a number of different ways.
When the document tabs are turned on, the corresponding tab should be simply pointed at with the . If the
document tabs are turned off, use key combinations or for consecutive
switching from one window to another.
Also, the list of open documents found in the textual menu “Window” can be used. The window that is
currently active will be marked by tick in this list. To make another window active it is sufficient to point at
it with the cursor and click .
The number of windows, shown in the list, cannot exceed ten. If there are too many documents open at the
moment, the command “Window|Window List…” can be used for selection of the specific window. After
calling this command, the dialog box “Arrange Windows” pops up. The desired window can be chosen in
this dialog box from the full list of open windows.
93