T-FLEX Parametric CAD. Fundamentals. 2D Design

Modifying Document Protection
Document Protection in T-FLEX CAD
The procedure of modifying access to protected
documents is similar to setting access to
documents. First, by using the option “Set or
Modify Access Rights for Documents”, select
the protected documents or a folder with
protected documents. In the list of files, select a
file, from which the protection parameters will
be read. If no such file is selected, then the
protection parameters will be read from the first
file in the list.
Depending on what type of “Change access” protection was used, the possibilities are as follows:
1. If the protection type was “Specific HASP Plug or list of HASP Plugs”, then, upon matching Key IDs,
the access for change will be granted.
2. If the protection type was “Password with HASP Plug”, then, upon pressing the button “Next”, a dialog
will appear, requesting the password for this protection. Upon entering the password, the access for
changing the protection will be also granted.
3. Otherwise, if the hardware key is missing that was used at the time
of setting this protection, or the password for accessing this
protection was not entered, then you can press the button “Cancel”.
In this case, an alternative access password will be asked. Upon
entering the alternative password, the access to changing the
protection will be granted.
Next, a dialog will be displayed with the protection parameters set for
the document. You can delete or change the parameters in this dialog.
725