T-FLEX Parametric CAD. Fundamentals. 2D Design

Fundamentals. Two-Dimensional Design
504
The parameters of dividing a drawing page into zones are defined in the command “ST: Set
Model Status”, on the tab “General”.
for nodes:
“X” – X-coordinate of the node;
“Y” – Y-coordinate of the node;
for construction lines:
lines:
“X”, “Y” – the coordinates of the first node the straight construction line is passing through;
“P1”, “P2” – the coordinates of the second node the straight construction line is passing through;
circles and ellipses:
“LENGTH” – the length of the circumferential;
“P1” – the radius of the circle (this parameter is specific to circles);
“X”, “Y” – the coordinates of the center of the circle;
splines, 2D paths, functions and offsets:
“LENGTH” – the entity length;
for graphic lines:
segments:
“LENGTH” – the segment length;
“START_X”, “START_Y” – the coordinates of the start point of the segment;
“END_X”, “END_Y” – the coordinates of the end point of the segment;
based on circles:
“LENGTH” – the length of the circle arc;
“CENTER_X”, “CENTER_Y” – the coordinates of the circle center;
“ANGLE” – the angular arc length of the graphic line;
“RADIUS” – the radius of the circle;
based on ellipses, splines, 2D paths, offsets and functions:
“LENGTH” – the entity length;
for graphic lines constructed as a circular or elliptical arc, portion of spline, 2D path, offset or
function, there are following additional parameters:
for hatches:
“START_X”, “START_Y” – coordinates of the arc start point;
“END_X”, “END_Y” – coordinates of the arc end point;
“AREA” – the hatch area;
“PERIMETER” – the hatch contour perimeter;
“XMASS” – X-coordinate of the center of gravity;
“YMASS” – Y-coordinate of the center of gravity;