T-FLEX Parametric CAD. Fundamentals. 2D Design

Fundamentals. Two-Dimensional Design
478
After calling this command the window “Options” opens up. At the left pane of the window, the list of all
possible columns from the table of variables will be displayed.
The majority of the columns correspond to some
characteristic of the variable (name, type,
usability, expression, current value, and so on).
The columns “State” and “Message” are used for
output of system messages about errors upon
evaluation of the value of variable.
The columns displayed at the current moment are
marked with a tick before the name. To add the
column into the table, it is enough to select it in the
list and with the help of put a tick before its
name. For removing a column from the table, it is
sufficient to take off a tick next to its name.
In the right pane of the window “Options” there are
other various parameters of the table of variables:
The group “Number Format” sets the format for the real numbers in the column “Value”: “Precision”
and “Trim Trailing Zeros”.
The group “Grid Lines” defines the appearance of the grid of the table of variables:
Vertical. The appearance of vertical lines of the grid of the table: “No”, “Small dots”, “Large dots”,
“Dashed”, “Solid”.
Horizontal. The appearance of horizontal lines of the grid of the table: “No”, “Small dots”, “Large
dots”, “Dashed”, “Solid”.