T-FLEX Parametric CAD. Fundamentals. 2D Design

Fundamentals. Two-Dimensional Design
394
Set relation with Circle *
Set relation with Dimension (on a circle) *
Set relation with Ellipse *
Set relation with Spline *
Select Other Element
Delete selected Element(s)
Cancel selection
* The respective attachment element selection option is available if the selected roughness symbol was
defined in the absolute coordinates, or if the attachment of this element was canceled by the option .
Once selected, the roughness symbol starts rubberbanding on the screen, following the pointer. The option
allows selecting which point of the roughness notation to rubberband - the arrow tip or the leader shelf.
Clicking fixes the roughness symbol in the new position.
To change the attachment type, first you need to cancel the original attachment by using the option
(). After that, the options will be provided in the automenu for selecting new attachment elements: ,
, , , . If the position of the selected roughness symbol was defined in the absolute
coordinates, then you do not need to use the first option .
Node, that roughnesses on lines, dimensions and circles can assume two opposite positions.
The option allows modifying parameters of the several selected
roughness symbols. Modifying parameters in the case of selecting a single
element is similar to defining the roughness parameters. However, if you
selected multiple roughnesses for editing, then you need to determine first,
which parameters to modify, in the “Change parameters” dialog box. By
default, all parameters of the selected elements are subject to editing.
Upon selecting parameters for editing and pressing [OK], you will access
the standard dialog box for defining roughness parameters.
Option takes parameters of roughness symbol from existing
roughness symbol.
To delete a roughness symbol, select it, and then press the key.