T-FLEX Parametric CAD. Fundamentals. 2D Design

Circle by center and radius
Sketch. Creating a Non-parametric Drawing. Automatic parameterization mode
This type of circle can be created using the automenu option:
Circle by center and radius
To create a circle, specify the position of the center and the radius (diameter). This can be done freely by the
mouse , or, alternatively, by entering the exact values of the center coordinates and the radius (diameter) in
the property window.
Circle through two points
Circle through two points
This option is intended for creating a circle passing through two points. The two points for the circle to pass
through can be defined by clicking or by entering coordinates in the property window. Next, define the
radius (diameter) of the circle. To do this, specify the third point with the mouse , defining the position and
the radius of the circle, or, again, resort to the property window.
Circle tangent to one entity
To create a circle tangent to one entity (an arc, circle or line segment), use the automenu option:
Circle tangent to one element
279