T-FLEX Parametric CAD. Fundamentals. 2D Design

1. No nodes neither construction lines are selected
The option creates a graphic entity – circle over
the selected underlying construction circle entity.
2. The start node alone is selected
The option selects a construction circle entity.
The start node stays highlighted, and an arc starts
rubberbanding along the selected circle. An
additional option appears in the automenu for
flipping the direction of the arc creation:
Change arc direction
3. A single construction entity is selected
The effects of using the option in this case are quite similar to the use of the option .
4. The start node and a construction entity are selected (line or circle)
The effects of using the option in this case are quite similar to the use of the option .
The options and are used similar to the option .
Example of Creating a Chain of Graphic Lines
Create a few construction lines. On top of them, draw the graphic lines:
To delete the last created graphic line, one can use the option .
Graphic Lines
263