T-FLEX Parametric CAD. Fundamentals. 2D Design

Fundamentals. Two-Dimensional Design
Constructing Circles
208
The command “C: Construct Circle” provides various options from the following list, depending on the
current state:
Select a node as the circle center
Set circle parameters
Select tangent line
Select a node for the circle to pass through
Select tangent circle
Select tangent ellipse
Select tangent spline
Select symmetry axis (line) to mirror the circle.
Select concentric circle
Select 2D projection
Change circle tangency
Construct a node at the nearest intersection of two
construction entities
Execute Edit Construction command
Cancel selection
Exit command
T-FLEX CAD supports the most common circle construction modes, which are:
- constructing a circle with the center at a selected node
- constructing a circle passing through a selected node
The following options initiate these modes:
Select a node as the center of the circle
Select a node for the circle to pass through
Upon calling the command, one of the modes is activated by default, as indicated by the pushed icon in the
automenu.