T-FLEX Parametric CAD. Fundamentals. 2D Design

Fundamentals. Two-Dimensional Design
“Main toolbar” tab
148
This tab displays the list of all main toolbar sets that are
defined in the system. The sets marked in the list by the
tick are displayed on the toolbar, unmarked sets are
hidden. It is possible to control visibility of the sets
independently, by removing/putting the tick (with the
help of ) located next to the name of the corresponding
set.
Double pressing on the name of any set activates the
set on the main toolbar.
The button [Rename] enables to assign another name to
any set of the main toolbar. After pressing this button, the
window for assigning the new name of the set appears.
Buttons [Up] and [Down] allow changing the order in
which the sets follow in the list.
To add the new (user's) set to the main toolbar the button
[New] is used. After pressing this button the system prompts to assign the name of the set being created.
Also, the prompt to add the standard buttons (i.e. related to command used for working with new documents,
files etc.) to the new set will appear on the screen. In case of negative answer, an empty set is created, in case
of positive one, the set containing only the standard buttons is created. Other buttons can be added to the
created set via the tab “Commands” (by using “drag&drop” method).
It is possible to remove the previously created user's set by selecting it in the list and pressing the button
[Remove] (for standard sets this button is not available).
The button [Create toolbar] enables to create a single toolbar on the basis of the set selected in the
list. Upon creating the toolbar, it is possible to automatically remove the standard buttons from it (by default,
these buttons are present practically in all standard sets of the main toolbar).
To make the work more convenient, several sets of main toolbar commands were assigned the key
combinations for quick call with the help of the keyboard (by default, these sets are “2D”, “Sketch”, “3D”).
If necessary, the key combinations can be also assigned for other sets (including user's defined ones). To do
it, the buttons [Assign] and [Reset] in the group “Keyboard” are used.
After pressing the button [Assign] the window opens up in which the required key combination for the
selected set has to be specified. For specifying the combination, it is just enough to press the corresponding
buttons simultaneously. If the combination is specified incorrectly, it is sufficient to press the correct
combination again. After closing the window with the help of [OK] the specified key combination will be
displayed in the list to the right of the name of the corresponding set.