UbiSurfer - Maplin Electronics

d) Choose the Authentication type and enter the network key (password) and click OK. The status of the connection will be listed on the
right beside the network name.
Figure 26.
e) On occasion, some networks will require a Static setting. If this is the case, before you connect, you must open these settings by
highlighting the network and clicking on the WLAN Setting Button, and then on the new interface, filling in the required information.
Figure 27.
Chapter 4
Getting Started
3) External Modems:
If you have an external modem connected into the USB port, to run it, click on the Datawind button and then click on Programs /
Internet / Mobile Connection to open the wireless dial-up setting interface.
Correctly fill in the information in each item on the interface. Should you require advanced settings, click on the Properties button and
fill them out as necessary. Click OK to enter the advanced properties and then Connect to connect using the external modem.
20