JANUS? 2020 Hand-Held Computer (4MB) - Intermec

AUTOEXEC.BAT (continued)
Command Line Definition
if not exist c:\fta.exe goto
DOS_PROMPT
e:
fta.exe checkhost; exit
%IM_APPLICATION%
:DOS_PROMPT
NF BC Learning About the Software
3
Runs the FTSERVER batch file if it is on drives C or D.
FTSERVER runs FTA.EXE, which provides binary file
transfer (BFT) on the JANUS device. If a host is trying to
initiate a BFT session, FTA continues running; if not, FTA
stops running.
After FTA terminates, %IM_APPLICATION% runs any
application identified by the DOS environment variable
IM_APPLICATION.
c: Resets the JANUS device to drive C or D.
cls Clears the screen.
CONFIG.SYS File
The CONFIG.SYS file on your 4MB JANUS device should look like this one:
Command Line Definition
[menu]
Creates the Startup menu.
menuitem=sram, Load PCCard
menuitem=ata, ATA PCCard
menuitem=flash, Flash PCCard
menuitem=io, I/O PCCard
menuitem=no, No PCCard
menucolor=15,0
menudefault=sram, 20
shell=command.com /e:2000 /p Increases the size of the environment space to 2000 bytes.
This line is required for Auto-Loader.
device=d:\himem.sys /testmem:off
dos=high
Loads the DOS extended memory manager, HIMEM.SYS.
You must load HIMEM before you load device drivers.
device=d:\power.exe /low Loads APM power management.
device=d:\sramdisk.sys 256 512 /e Creates the 256K RAM drive E.
install=d:\card_sr.exe Loads software required for the PC card drives.
3-9