JANUS? 2020 Hand-Held Computer (4MB) - Intermec

JANUS 2020 Hand-Held Computer User’s Manual (4MB) NF BC
Intersvr (continued)
Notes: (cont.) Copying the files from the reader If you do not have the MS-DOS Programs
companion disk, which contains the Interlnk and Intersvr files, you can copy
the files from the reader. You need to connect the host computer to the reader
using a 7-wire, null-modem serial cable and the Mode command must be
available on the host computer where you are installing Interlnk. To copy the
files to the host computer, type this command on the reader:
D-8
intersvr /rcopy
Using a serial mouse with Microsoft Windows If you are using a serial mouse
with Microsoft Windows, and you start Intersvr while Windows is running,
specify the /com switch to designate a COM port other than the one the
mouse is using.
Using Interlnk in a task-switching or multitasking environment If you start
Intersvr in a task-switching or multitasking environment, task-switching and
key combinations that switch you out of your current task are disabled. To
restore these functions, quit the server.
Limitations These commands do not work on the device running Intersvr:
CHKDSK FORMAT UNDELETE
DISKCOMP MIRROR UNFORMAT
DISKCOPY SYS
Interlnk does not redirect network, CD-ROM drives, or any other device that
uses a redirection interface. For example, you cannot access a network drive
that was redirected before Interlnk was started.
Examples: If you have two computers and each contains drives A, B, and C, you can start
Intersvr and direct server drive C to client drive D, and A to E, and B to F, by
typing this command on the server:
intersvr c: a: b:
To redirect all server drives except drive A and use COM4 to connect to the
client, type this command on the server:
intersvr /x=a /com4