JANUS? 2020 Hand-Held Computer (4MB) - Intermec

Configuration Commands by Syntax (continued)
NF BC Reader Specifications
Syntax Command For Help, See Page
PAdata Communications Protocol, Activate 12-41
PCdata RES (Reset) 12-83
PDdata REQ (Request for Acknowledge) 12-82
PEdata SOM (Start of Message) 12-90
PFdata EOM (End of Message) 12-53
PGdata AFF (Affirmative Acknowledge) 12-8
PHdata NEG (Negative Acknowledge) 12-74
PIdata Transmit EOM (End of Message) Only 12-53
PJdata Receive EOM (End of Message) Only 12-53
PMdata Communications Protocol, User-Defined Multi-Drop 12-42
PSdata Communications Protocol, Configure 12-38
Rchannel data RF Channel Allow See RF guide
RFdata RF Protocol See RF guide
RHdata RF Device Address See RF guide
RLdata RF Retry Limit See RF guide
RMdata RF Acknowledgment Delay See RF guide
RTdata RFNC (RF Network Controller) Address See RF guide
RUdata RF Repeat Count See RF guide
RVdata RF Channel Select See RF guide
RWdata RF Network ID See RF guide
RXdata RF Duty Cycle Period See RF guide
RYdata RF Duty Cycle Percent See RF guide
SAdata Scanner Timeout 12-87
SBdata Scanner Mode 12-85
SCdata Scanner Trigger 12-88
SDdata Scan Ahead 12-84
SRdata Scanner Redundancy 12-86
WMdata Key Code Look-Up Table 12-67
XAdata IRL SOP (Start of Program) 12-66
XBdata IRL EOP (End of Program) 12-62
A
A-13