JANUS? 2020 Hand-Held Computer (4MB) - Intermec

JANUS 2020 Hand-Held Computer User’s Manual (4MB) NF BC
Viewport Movement Mode (continued)
Syntax: DZdata
Acceptable values for data are:
0 Enable Manual Viewport Movement mode
1 Enable Automatic Viewport Movement mode
Scan: One of these bar codes:
12-100
Enable Manual Viewport Movement Mode
*$+DZ0*
*$+DZ0*
Enable Automatic Viewport Movement Mode
*$+DZ1*
*$+DZ1*
Viewport Movement Steps
Purpose: Defines the number of horizontal and vertical steps the viewport moves when
you enter a viewport up, down, right, or left command. The horizontal steps
are the number of characters the viewport moves left or right. The vertical steps
are the number of lines or rows the viewport moves up or down. You must set
the Display Setup command to 25 x 80 before you can move the viewport. For
help, see “Display Setup” earlier in this chapter.
Default: 10 horizontal steps and 9 vertical steps
Syntax: DYdata
Acceptable values for data are:
1-20H 1 to 20 horizontal steps or characters
1-9V 1 to 9 vertical steps or lines
Scan: To define the number of steps:
1. Scan this bar code:
Enter Accumulate Mode / Viewport Movement Steps
*+/$+DY*
*+/$+DY*