JANUS? 2020 Hand-Held Computer (4MB) - Intermec

JANUS 2020 Hand-Held Computer User’s Manual (4MB) NF BC
Timeout Delay
Purpose: Defines the length of time the reader waits between characters when receiving
a message. When the timeout expires, an I/O error occurs.
Default: 10 sec
12-92
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see “Communications Protocol,
Configure” earlier in this chapter.
If you are using User-Defined or Point-to-Point protocol, you should only set the
Timeout Delay command if the baud rate is 9600 or lower. You should disable Timeout
Delay if the baud rate for either of these protocols is set to 19200 or higher.
Syntax: IEdata
Acceptable values for data are:
0 5 ms
1 100 ms
2 500 ms
3 2 sec
4 10 sec
5 20 sec
6 40 sec
7 60 sec
8 No timeout
Scan: One of these bar codes:
No Timeout Delay Timeout Delay, 5 ms
*$+IE8* *$+IE0*
*$+IE8* *$+IE0*
Timeout Delay, 100 ms Timeout Delay, 500 ms
*$+IE1* *$+IE2*
*$+IE1* *$+IE2*