JANUS? 2020 Hand-Held Computer (4MB) - Intermec

IRL Run
12
NF BC Configuration Command Reference
Purpose: Designates the end of an IRL program download and causes the reader to
execute the program. The Run command takes the place of the last EOP
character in the downloaded program.
Default: DC2
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see “Communications Protocol,
Configure” earlier in this chapter.
Syntax: XCdata
where data can be any ASCII character.
Scan: To disable IRL Run, scan this bar code:
Disable IRL Run
*$+XC*
*$+XC*
Or: To set IRL Run to an ASCII character:
1. Scan this bar code:
Enter Accumulate Mode / Set IRL Run
*+/$+XC*
*+/$+XC*
2. Scan a bar code for data from the “Full ASCII Bar Code Chart” in
Appendix C.
3. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
12-65