JANUS? 2020 Hand-Held Computer (4MB) - Intermec

IRL End Program Block
12
NF BC Configuration Command Reference
Purpose: Indicates the last block of an IRL program when you download a program to
the reader.
Default: SO (shift out)
Note: You must select the communications port and protocol before you set the
parameters to define that protocol. For help, see “Communications Protocol,
Configure” earlier in this chapter.
Syntax: XDdata
where data can be any ASCII character.
Scan: To disable IRL End Program Block, scan this bar code:
Disable IRL End Program Block
*$+XD*
*$+XD*
Or: To set IRL End Program Block to an ASCII character:
1. Scan this bar code:
Enter Accumulate Mode / IRL End Program Block
*+/$+XD*
*+/$+XD*
2. Scan a bar code for data from the “Full ASCII Bar Code Chart” in
Appendix C.
3. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
12-61